Panasonic Viera TH-32LHD7 Operating Instructions Manual

Panasonic Viera TH-32LHD7 Operating Instructions Manual Manual pdf 10 page image

10ConnectionsPC Input Terminals connectionNotes:• Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and verticalscanning frequency of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200lines.)• The display resolution is a maximum of 1,024 × 768 dots when the aspect mode is set to “NORMAL”, and 1,366 × 768dots when the aspect mode is set to “FULL”. If the display resolution exceeds these maximums, it may not be possibleto show fine detail with sufficient clarity.• The PC input terminals are DDC1/2B-compatible. If the computer being connected is not DDC1/2B-compatible, youwill need to make setting changes to the computer at the time of connection.• Some PC models cannot be connected to the set.• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.• The computer shown in the illustration is for example purposes only.• Additional equipment and cables shown are not supplied with this set.• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifiedfrequency range.Signal Names for D-sub 15P ConnectorPin Layout for PC InputTerminalAUDIOPC INTH-32LHD7COMPUTERConversion adapter(if necessary) D-sub 15pRGBPC cableFerrite core(Small size)(supplied)Less than3" 15 /16(10 cm)Stereo plugAudioConnect a cable which matchesthe audio output terminal on the computer.1 2 31 2 3Installing the ferrite core (Small size)Installing the ferrite core (Large size)Pull back the tabs(in two places)OpenPull back the tabs(in two places)OpenPress the cablethrough and closePress the cablethrough and close16 7 8394 51015141312112Pin No. Signal Name Pin No. Signal Name Pin No. Signal Name1 R (PR /CR ) 6 GND (Ground) 11 GND (Ground)2 G (Y) 7 GND (Ground) 12 SDA3 B (PB/CB) 8 GND (Ground) 13 HD/SYNC4 GND (Ground) 9 NC (not connected) 14 VD5 GND (Ground) 10 GND (Ground) 15 SCLLess than3" 15 /16(10 cm)Less than3" 15 /16(10 cm)Ferrite core (large size)(supplied)