Panasonic Viera TC-P65ST60 Owner's Manual

Also see for Viera TC-P50ST60: Owner's manual Owner's manual Service manual Technical guide Technical guide

Contents

Panasonic Viera TC-P65ST60 Owner's Manual Manual pdf 5 page image

5● Do not place the Plasma TV or its stand on asloped or unstable surface.The Plasma TV may fall or tip over.● Do not support the Plasma TV on a non-specified pedestal.● Do not place the Plasma TV on furniture that caneasily be used as steps, such as a chest of drawers.● Do not climb or allow children to climb on the Plasma TV● Place or install the Plasma TV where it cannotbe pushed, pulled over or knocked down.● Route all cords and cables such that they cannotbe tripped over or pulled by curious children.● Do not place any objects on top of the Plasma TV.If water spills onto the Plasma TV or foreignobjects get inside it, a short-circuit may occur,which could result in fire or electric shock. If anyforeign objects get inside the Plasma TV, pleaseconsult an Authorized Service Center.● In the unlikely event that you receive a shockfrom this product, it is possible that yourhousehold outlet may be wired improperly.Have an electrician verify that the TV’s outlet isproperly wired. If the symptom persists, have theTV serviced by a qualified authorized technician.● To prevent the spread of fire, keepcandles or other open flames awayfrom this product at all times■AC Power Supply CordTo prevent fire or electric shock:● The Plasma TV is designed to operate on a 120V AC, 60 Hz service. Insert the power cord plugas far as it will go into the wall socket.If the plug is not fully inserted, heat may generate,which could cause a fire.● The included power cord is for use with this unit only.● Do not use any power cord other than thatprovided with this TV.● Do not handle the power cord plug with wet hands.● Do not do anything that might damage thepower supply cord.● When disconnecting the power supply cord,hold the plug, not the cord.● Do not use the power supply cord if the plug orcord is damaged.Replace the cord or contact your Authorized Service Center.● Do not use a 3-prong to 2-prong AC plug adaptersto connect your TV’s plug to the wall outlet.Doing so will defeat the TV plug’s safety feature,which can lead to a shock hazard. If the wall outletdoes not accommodate a 3-prong plug, have aqualified electrician replace your outlet and checkthe associated wiring.● If water or an object gets inside the Plasma TV, if thePlasma TV is dropped, or if the enclosure becomesdamaged, unplug the power supply cord immediately.A short-circuit may occur, which could cause a fire.Contact an Authorized Service Center for an evaluation.■Radio waves● Do not place this TV in any medical institutionsor locations with medical devices.Radio waves from this TV may interfere with the medicaldevices and cause accidents due to the malfunction.● Do not use this TV near any automatic controldevices such as automatic doors or fire alarms.Radio waves from this TV may interfere with theautomatic control devices and cause accidentsdue to the malfunction.● Keep this TV away at least 9 inches (22 cm) from thelocation where a cardiac pacemaker is implanted.Radio waves from this TV may interfere with theoperation of the pacemaker.■Handling the power supply cord● Inse rt the power plug fully into the socket outlet.(If the power plug is loose, it could generate heatand cause fire.)● Ensure that the power plug is easilyaccessible.● Ensure the earth pin on the power plug issecurely connected to prevent electrical shock.• An apparatus with CLASS I construction shallbe connected to a power socket outlet with aprotective earthing connection.● Do not touch the power plug with a wet hand.(This may cause electrical shock.)● Do not use any power cord other than thatprovided with this TV. (This may cause fire orelectrical shock.)● Do not damage the power cord. (A damagedcord may cause fire or electrical shock.)• Do not move the TV with the cord plugged in thesocket outlet.• Do not place a heavy object on the cord or placethe cord near a high-temperature object.• Do not twist the cord, bend it excessively, orstretch it.• Do not pull on the cord. Hold onto the powerplug body when disconnecting cord.• Do not use a damaged power plug or socketoutlet.● If a problem occurs (such as no picture orno sound), or if smoke or an abnormal odoris detected from the Plasma TV, unplug thepower supply cord immediately.Continued use of the TV under these conditionsmight cause a fire or permanent damage to the TV.Have the TV evaluated by an Authorized ServiceCenter. Servicing of the TV by unauthorizedpersonnel is strongly discouraged due to its highvoltage.