Panasonic Viera TC-P65ST60 Owner's Manual

Also see for Viera TC-P50ST60: Owner's manual Owner's manual Service manual Technical guide Technical guide

Contents

Panasonic Viera TC-P65ST60 Owner's Manual Manual pdf 23 page image

23RegistrationFirst registrationPerform the first registration when the 3D Eyewear is used for the first time.Turn the TV onPress the button for about 1 second to turn the power on.The lamp lights for about 2 seconds and then flashes.The 3D Eyewear will be turned on and start registration.Place the 3D Eyewear within 1.6 ft (50 cm) from the TV while registration in progress.When the registration is successfully completed, the 3D Eyewear will reconnect with TVautomatically when 3D Eyewear is turned on near the TV in 3D mode.Registration againWhen connection with registered TV fails, or when using with another TV, re-register the 3D Eyewear.Turn the TV onWithin 1.6 ft (50 cm) from the TV, press Power button until lamp lights, then release it tostart registration.When the registration is successfully completed, the 3D Eyewear will reconnect with TVautomatically when 3D Eyewear is turned on near the TV in 3D mode.NoteIf the registration failed, the 3D Eyewear will power off.In this case, power off the TV and perform from step .Please refer to eHelp (p. 21) for more details.Viewing 3D imagesUsing the television menu controls, set so that 3D images are shown.● You can watch 3D images in the following cases:• When a 3D image supporting Blu-ray Disc is played on a 3D image supporting player/recorderconnected using a HDMI cable to a 3D image supporting television.• 3D image supported broadcast (program)• 3D Photo, 3D Movie taken by LUMIX/Camcorder.Turn the 3D Eyewear on and put it onMake sure that registration is finished completely.(Displays messages and information on the screen.)ViewWhen the TV receives a 3D signal, it also tries to detect the 3D mode (format). 3D images areautomatically displayed according to the signal. If the 3D images are not displayed correctly or theimages cause discomfort, the images can be adjusted by 3D format select or 3D settings.Turn off the 3D EyewearThe 3D Eyewear indicator lamp turns off, and the power turns off.Please refer to eHelp (p. 21) for more details.Change the view 3D⇔2D■Simply switches 3D ⇔ 2D images (Auto mode)(example)● Switches to Manual mode3D format select3D2DselectOK