Installing the door stationImportant:LOn the bottom surface of the door station, there are holes to allow water to drain.Do not cover them up when installing.1 Remove the mounting base.A Open the screwcover.TScrewdriverMounting baseB Loosen themounting screw.Water drainholes2 Attach the mounting base to the wall securely using the wood screws (3.8 mm x 20 mm).LInstall the mounting base on a vertical flat wall.LBefore drilling, refer to “Before installation” for installation location.83.5 mmWallWire (Not included)Mounting baseWood screws3 Adjust the camera angle using the camera angle control lever.LThe angle can also be adjusted to the leftor upper left. Rear view Camera anglecontrol leverLeft(maximum 15°)Right(maximum 15°)Upwards(maximum 15°)Important:LWhen the camera angle is adjusted to the upper left or upper right, the image may be slightlydistorted.4 Connect the wire, then mount the door station to the mounting base.C Fasten the screw, thenclose the screw cover.A Unscrew the screws.Push in the wire to the terminal connectors(non polar), then tightly fasten the screws.Wire (connecting to the main monitor station)B Mount the door station tothe mounting base.Installing the main monitor station1 Attach the mounting bracket to the wall securely using the wood screws (4 mm x 16 mm).LInstall the mounting bracket on a vertical flat wall.LBefore drilling, refer to “Before installation” for installation location.83.5 mmWood screwsWallWire (Not included)Mounting bracket2 Attach the wires connected to the door station to the terminal connector.LConnect the wire correctly according to “Wiring schematic diagram”.LWhile pressing on the button with a pointed object such as a screwdriver, insert the wire intothe terminal connector. (To disconnect a wire, press on the button while pulling out.)Wire from the door stationStripped end ofthe wire9 mmTerminalconnectorButton3 Mount the main monitor station to the mounting bracket.A Fit into position as shown in the figure.B Push the main monitor station down until it is secure.BA4 Connect the plug into an AC outlet (100 – 240 V AC).To connect the plug to the power outlet which is not easily accessibleImportant:LIf you want to connect the plug to the power outlet which is in the wall or is not easilyaccessible, install a main disconnect device near the main monitor station.LUse a main disconnect device with minimum 3 mm contact spacing inside the device andshowing “ON” and ”OFF”.To use an existing wire in your home1 Be sure to turn off the power and confirm that the wire type is CAT-3 (ø0.5) or 22 AWG(ø0.65). If the wire type is not CAT-3 (ø0.5) or 22 AWG (ø0.65), change the wire to either of thespecified wire types.2 Install the main monitor station and the door station.3 Turn on the power.
