Panasonic VL-SVN511 Quick Start Manual

Also see for VL-SVN511 Series: Installation guide Operating instructions Installation guide Operating instructions Manual

Panasonic VL-SVN511 Quick Start Manual Manual pdf 1 page image

12D1D234D3D4 56R1R278R3IN1 910IN2IN311IN412P113P2PowersupplyPowersupplyDOORPHONE 1* DOORPHONE 2*MAIN MONITORPOWER SUPPLY UNIT24 V DCNPNPNPNPNPNPElectric lockElectric lock220-240 V AC Connection devicefor option input(A contact)Terminal box(4-conductorwiring)PBX* 312 V AC/DC12 V AC/DCNP NPRELAY BOXABCDEFGR11R2 R3S21S1 S42S32Key Features• Smartphone Connect: You can use your smartphone or tablet as a sub monitor to respond to visitors and unlock electric locks no matter where you are in thehome. You can also monitor doorphone images when you want to check the door entrance. Maximum of 4 supported smartphones/tablets can be connected.* The main monitor must be on the same home Wi-Fi network as a smartphone/tablet (with the dedicated app installed).* It is also necessary to run the dedicated app in order to receive visitor's calls on a smartphone/tablet.* Compatible mobile devices: iPhone 5 and later and iPad (iOS 7.0 or later) / AndroidTM smartphones and tablets (Android 4.0 or later)* Some mobile devices may not be compatible.* For the latest information about the app and compatible devices, visit the following website. http://panasonic.net/pcc/support/intercom/smartphone/• E-mail Notification: The main monitor can send e-mail with a time stamp and image of visitors to e-mail addresses registered in advance, enabling you tocheck who has visited when you are outside the house (even when you are overseas).When commercially available sensors (such as a fire alarm, calling button, etc.) are connected to the main monitor, you can receive notifications.* To use this function, a main monitor with e-mail sender information registered must be connected to the internet.* E-mail may not be able to be sent depending on the condition of the network.• Wi-Fi Connection: In addition to smartphones/tablets, the main monitor can also wirelessly connect to the Wi-Fi router for easy connections without a cable.You can configure Wi-Fi settings using a simplified method (called WPS).• Electric Lock Release Support: The gate or door lock can be easily and quickly unlocked with either the main monitor or a mobile device such as asmartphone/tablet, even from the second floor of the house.• Picture Recording Function: The Main Monitor records the images of up to 400 (50 visitors, 8 shots per visitor).• Voice Change Function: This function makes woman’s voice (higher keys) sounds like a man’s (lower keys).• Night Vision: Door Station is equipped with LED lights (illumination lamp). It enables the colour display of visitors at a distance of about 50 cm at night.Wiring schematic diagramAccessory Information Optional Accessories Relative ProductVL-SVN511Video Intercom SystemCMOS 0.3 M pixelsVL-V555(Surface mount)Door Station (Doorphone)Main MonitorStation(Main monitor)VL-MVN511CMOS 1.0 M pixelsVL-V554(Surface mount)VL-V554U(Flash mount)For the Door Station:Screw (3.8 mm x 20 mm) x 2Relay Box and Related Items:Relay box × 1, Cable binder × 1, Screw (4 mm x 40 mm) x 2For the Main Monitor Station:Mounting bracket × 1, Cable binder × 1,Screw (4 mm x16 mm) x 2, Power supply unit (VL-PS241) × 1,AC cable x 1, Cable binder x 1, Screw (4 mm x 40 mm) x 2Wire type and length*1 Type: Single-pair cable with outer sheath (jacket)Conductor: Copper solid• A certified power supply wiring has to be used with this equipment. The relevant nationalinstallation and/or equipment regulations shall be considered. A certified power supply wiringnot lighter than ordinary polyvinyl chloride flexible wiring according to IEC 60227 shall be used.*2 When using an electric lock or a connection device for option input (A contact), select adevice that meets the following guidelines:• Electric lock connection terminal (S1/S2, S3/S4):– N/O dry closure contact– 12 V AC/DC, less than 1 A• Connection device for option input (A contact) terminal (IN1/IN2/IN3/IN4):– Input method: No-voltage contact– Open-circuit voltage between terminals: DC 7 V or less– Detection definite time: 0.1 second or more– Short-circuit between terminals: 5 mA or less– Resistance value: make: 500 Ω or less make, break: 15 KΩ or more*3 Connectable PBX Model Numbers:KX-TDA30/100/100D/200/600 series, KX-TDE100/200/600 series,KX-NS300/500/700/1000 seriesPlease consult your dealer when connecting with a PBX.Lobby StationVL-V590Up to 20 mainmonitors can beconnected.*When you use an additional doorphone, the maximum number of the electric locks that can be connectedto the doorphone depends on the type of doorphone. Consult your dealer for further information.Wiring run Wire type*1Diameter Length (Max.)Main monitor – Doorphone(including lobby station) Aφ 0.65 mm 22 AWG 100 mφ 1.0 mm 18 AWG 130 mφ 0.5 mm CAT 5 50 mMain monitor – Power supply unit B φ 0.65 mm 22 AWG 10 mφ 1.0 mm 18 AWG 20 mPower supply unit – AC power source C φ 1.2 mm - φ 2.0 mm (17 AWG - 12 AWG) No requirementMain monitor – Relay box D φ 0.65 mm 22 AWG 100 mφ 1.0 mm 18 AWG 130 mRelay box –Electric lock *2 E φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to specification of connected device.Main monitor – Connection device for option input (A contact)*2 F φ 0.5 mm - φ 1.2 mm (24 AWG - 17 AWG) According to specification of connected device.Main monitor – PBX G φ 0.65 mm CAT 3 or 22 AWG 100 mNP: Non-polarisedDoor Station(Doorphone)VL-V522L(Surface mount)

/ 2

Related manuals for Panasonic VL-SVN511 Series