Important Information4For your safetyTo prevent severe injury and loss of life/property, read this section carefully before using the unit to ensureproper and safe operation of your unit.WARNINGPower connectionLUse only the power source marked on the unit. If you are not sure of the type of power supplied to your home,consult your dealer or local power company.LDo not place objects on the power cord. Install the unit where no one can step or trip on the cord.LDo not overload power outlets and extension cords. This can result in the risk of fire or electric shock.LCompletely insert the power plug into the power outlet. Failure to do so may cause electric shock and/orexcessive heat resulting in a fire.LRegularly remove any dust, etc. from the power plug by pulling it from the power outlet, then wiping with a drycloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.LUnplug this unit from power outlets if it emits smoke, an abnormal smell or makes unusual noise. Theseconditions can cause fire or electric shock. Confirm that smoke has stopped and contact an authorized servicecenter.LNever touch the plug with wet hands. Danger of electric shock exists.InstallationLTo prevent the risk of fire or electrical shock, do not expose the product (excluding the door station) to rain orany type of moisture.LDo not allow the power cord to be excessively pulled, bent or placed under heavy objects.Operating safeguardsLTo reduce the risk of electric shock, do not disassemble this unit. Refer servicing to an authorized servicecenter when service is required. Opening or removing covers may expose you to dangerous voltages or otherrisks. Incorrect reassembly can cause electric shock when the unit is subsequently used.LDo not touch the main monitor station and the power plug during an electrical storm. There may be a remoterisk of electric shock from lightning.LNever push any objects through slots in this unit. This may result in the risk of fire or electric shock. Never spillany liquid on the unit.LUnplug this unit from power outlets and refer servicing to an authorized service center when the followingconditions occur:A. If the power cord is damaged or frayed.B. If metal objects have been dropped inside the main monitor station.C. If the main monitor station has been exposed to rain or water, or liquid has been spilled into the unit. Do notuse a microwave oven to speed up the drying process of any parts of the unit to avoid permanent damage.D. If the unit has been dropped or physically damaged.CAUTIONInstallation and relocationLThe power cord is used as the main disconnect device. Ensure that the power outlet is installed near theproduct and is easily accessible.Operating safeguardsLDo not put your ear(s) near the speaker, as loud sounds emitted from the speaker may cause hearingimpairment.