– 166 –Chapter 11 Network Connection — Connecting the remote operation panel (AK-HRP200G)Connecting the remote operation panel (AK-HRP200G)Part of the function can be remotely controlled by connecting the remote operation panel AK-HRP200G (optional) via IP connection.Playback operation is not possible from the remote operation panel AK-HRP200G. Playback can only be performed from the camera.LAN cable (cross cable) (optional)AK-HRP200GSetting for connection with the remote operation panel (AK-HRP200G)To connect AK-HRP200G via network to set the camera to the remote control mode, configure the settings in the following procedure.1 Configure the network settings of the camera.Set [MENU] → [PERIPHERAL] → [LAN PROPERTY] → [DHCP] to [DISABLE], and set following the Steps 1 to 2 in “Wired LAN settings”(page 162).2 Set each item in [MENU] → [PERIPHERAL] → [NETWORK FUNC] → [USER ACCOUNT] in the camera.[USER NAME]: Sets the user account name. (Factory setting: [guest])[PASSWORD]: Sets the password. (Factory setting: [p2guest])Enter up to 31 characters for a user account, and characters between 6 and 15 for a password.3 Configure the network settings of AK-HRP200G.For the network settings, use the ROP setup software application supplied with AK-HRP200G.@@ NOTEt The following information is required to connect to AK-HRP200G.- User account name- Password- IP address- Port number: 49152t Use versions above Ver3.00.00 for AK-HRP200G.t For details on operating the ROP setup software, refer to AK-HRP200G operation manaul.t Use versions above Ver3.00.00 for ROP setup software.
