Panasonic UT-MA6 series Operating Instructions Manual

Also see for UT-MA6 series: Operating instructions INSTALLATION PROCEDURE Before using Operating instructions

Contents

Panasonic UT-MA6 series Operating Instructions Manual Manual pdf 6 page image

6Read Me FirstRegulatory InformationFor U.S.A.Federal Communications Commission Radio Fre-quency Interference StatementNote: This equipment has been tested and found to com-ply with the limits for a Class B digital device, pursuantto Part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmful interfer-ence in a residential installation. This equipment gener-ates, uses and can radiate radio frequency energy and, ifnot installed and used in accordance with the instructions,may cause harmful interference to radio communications.However, there is no guarantee that interference will notoccur in a particular installation. If this equipment doescause harmful interference to radio or television recep-tion, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct theinterference by one or more of the following measures:l Reorient or relocate the receiving antenna.l Increase the separation between the equipment and receiver.l Connect the equipment into an outlet on a circuit dif-ferent from that to which the receiver is connected.l Consult the Panasonic Service Center or an experi-enced radio/TV technician for help.WarningTo assure continued compliance, use only shielded inter-face cables when connecting to a computer or peripheral.Also, any changes or modifications not expressly ap-proved by the party responsible for compliance could voidthe user’s authority to operate this equipment.FCC RF Exposure Warning:l This equipment is provided with PC Card slot that couldbe used with wireless transmitters, which will be specifi-cally recommended when they become available.Other third-party wireless transmitters have not beenRF exposure evaluated for use with this computer andmay not comply with FCC RF exposure requirements.l This equipment complies with FCC radiation exposurelimits set forth for an uncontrolled environment.l This equipment may not be co-located or operatedwith any other antenna or transmitter.l This device meets the government’s requirements forexposure to radio waves.This device is designed and manufactured not toexceed the emission limits for exposure to radio fre-quency (RF) energy set by the Federal Communica-tions Commission of the U.S. Government.l The exposure standard for wireless device employs aunit of measurement known as the Specific AbsorptionRate, or SAR. The SAR limit set by the FCC is1.6 W/kg.* Tests for SAR are conducted using standard operat-ing positions accepted by the FCC with the devicetransmitting at its highest certified power level in alltested frequency bands.Although the SAR is determined at the highest certi-fied power level, the actual SAR level of the devicewhile operating can be well below the maximumvalue. This is because the device is designed to op-erate at multiple power levels so as to use only theposer required to reach the network. In general, thecloser you are to a wireless base station antenna,the lower the power output.This product is restricted to indoor use due to its operationin the 5.15 to 5.25 GHz frequency range. FCC requires thisproduct to be used indoors for the frequency range 5.15 to5.25 GHz to reduce the potential for harmful interferenceto co-channel Mobile Satellite systems. High power radarsare allocated as primary users of the 5.25 to 5.35 GHz and5.65 to 5.85 GHz bands. These radar stations can causeinterference with and/or damage this product. 25-M-W-1This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and(2) This device must accept any interference received, in-cluding interference that may cause undesired operation.Responsible Party: Panasonic Corporation of North AmericaTwo Riverfront Plaza,Newark NJ 07102Support Contact: http://www.panasonic.com/contactinfo6-M-1CAUTION:Risk of Explosion if Battery is replaced by an Incorrect Type. Dispose of Used Batteries According to the Instructions.58-E-1ATTENTION:Il y a risque d’explosion si la batterie est remplacée par une batterie de type incorrect.Mettre au rebut les batteries usagées conformément aux instructions.58-F-1