Panasonic ToughBook CF-50 Series Operating Instructions Manual

Also see for Touchbook CF-50 Series: Operating instructions Operating instructions Manual Reference manual Operating instructions

Panasonic ToughBook CF-50 Series Operating Instructions Manual Manual pdf 21 page image

21 TroubleshootingActionIf a floppy disk is set in the floppy disk drive, remove the disk and press any key.If an external keyboard or mouse is connected, disconnect these devices.An error has occurred in the memory that stores the Setup Utility settings. This error occurswhen the memory content is changed through some inadvertent operation by a program orother function.Run the Setup Utility and load the default values, then change the settings to the appro-priate values as needed.If the problem persists, the internal clock battery may need to be replaced. Contact Pana-sonic Technical Support.The data and time setting are incorrect.Run the Setup Utility and set the date and time correctly.If the problem persists, the internal clock battery may need to be replaced. Contact Pana-sonic Technical Support.Startup has failed repeatedly, so the Setup Utility settings have been returned to their defaultvalues, and the computer has been restarted.Run the Setup Utility and load the default values, then change the settings to the appropri-ate values as needed.Write down the error details and press F2 to run the Setup Utility. Confirm the settings,and change the settings to the appropriate values as needed.The OS is not properly installed on the floppy disk or the hard disk that you are trying toboot from.If the computer cannot be booted from the floppy disk, check the floppy disk drive toensure that the disk is in fact bootable, and change it to another if not.If the computer cannot be booted from the hard disk, confirm whether the hard disk isproperly recognized in [Information] menu of the Setup Utility.If the hard disk is recognized, perform the reinstallation procedure. If not, contact Pana-sonic Technical Support.List of Error CodesError Code/MessageInvalid system disk.Replace the disk, and thenpress any key0211: Keyboard error0 2 5 1 : S y s t e m C M O Schecksum bad - Default con-figuration used0271: Check date and time set-tings0280: Previous boot incomplete- Default configuration usedPress to resume, toSetupOperating System not foundHow to run the Setup Utility1 Restart the computer.2 Press F2 while [Panasonic] boot screen is displayed soon after the computer begins the startup procedure.When turning on the computer, if one of the following error codes or messages is displayed, follow the instructions shown below.If the problem persists, or if the error code or message displayed is not shown here, contact Panasonic Technical Support. ( page 40)