Panasonic TX-PF42G30 Service Manual

Also see for TX-P42G30E: Operating instructions Operating instructions

Panasonic TX-PF42G30 Service Manual Manual pdf 9 page image

95 Technical Descriptions5.1. Specification of KEY for CI Plus, DTCP-IP, WIDEVINE and One-to-One5.1.1. General information:1. EEPROM (IC8902) for spare parts has the seed of KEY for each.2. The final KEY data will be generated by Peaks IC (IC8000) when SELF CHECK was done and are stored in both Peaks IC(IC8000) and EEPROM (IC8902).Three KEY are not generated for all models.The necessary KEY are only generated and stored depend on the feature of models.5.1.2. Replacement of ICs:When Peaks IC (IC8000) is replaced, EEPROM (IC8902) should be also replaced with new one the same time.When EEPROM (IC8902) is replaced, Peaks IC (IC8000) is not necessary to be replaced the same time.After the replacement of IC, SELF CHECK should be done to generate the final KEY data.How to SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press [MENU] button on the remote control for morethan 3 seconds.TV will be forced to the factory shipment setting after this SELF CHECK.5.1.3. Model and Keys:5.2. USB HDD Recording5.2.1. General information:Digital TV programmes can be recorded in USB HDD.A One-to-One key generated in A-board by SELF CHECK binds TV and USB-HDD for communication.That key is only one key for them. If the key is difference, TV can not access USB-HDD.Caution:New key will be generated by following SELF CHECK and previous TV programmes recorded in USB HDD will not beviewed.SELF CHECK: While pressing [VOLUME ( - )] button on the main unit, press [MENU] button on the remote control formore than 3 seconds.Model No. KeysOne-to-One(For USB Rec.)CI Plus DTCP-IP WIDEVINETX-P42G30E Yes Yes Yes YesTX-P42G30J Yes Yes Yes YesTX-PF42G30 Yes Yes Yes Yes