Panasonic TX-40DSW404 Operating Instructions Manual

Contents

Panasonic TX-40DSW404 Operating Instructions Manual Manual pdf 26 page image

English263 Select the USB HDD for recording andstart setupUSB Drive AUSB Flash DiskUSB Device SetupProduct Nameselectstart setup● Follow the on-screen instructions.Recording1 Display the menu and select [Setup]Setupselectaccess2 Select [Recording Setup]selectaccess[One Touch Recording]Records the current programme to the USB HDDimmediately.● Confirm the remote control code is “73” (p. 22).Select the maximum recording time1/2One Touch Recording 180 minutesRecording Setupselectaccess / store■ To start One Touch Recording[REW LIVE TV]Records the current programme to the USB HDDconstantly within the maximum recordable time.● Confirm the remote control code is “73” (p. 22).Select [Auto] to start [REW LIVE TV]REW LIVE TV AutoRecording Setupselectaccess / start [REW LIVE TV]● When you select [Auto], recording will startautomatically.● This recording may not start if another recording is inprogress, TV signal condition is bad or there are noimages displayed.■ To operate [REW LIVE TV]● To pause● To search backward (up to 90 minutes)● After pausing or searching backward, the followingbuttons are available for operation.Search backwardPlayback / Pause/Search forwardReturn to the current programme■ To stop [REW LIVE TV]REW LIVE TVRecording SetupAutoOffselect [Off]store● If you stop [REW LIVE TV], the recorded content for[REW LIVE TV] will be deleted.● [REW LIVE TV] is stopped and the recorded contentis deleted automatically in the following conditions:(Even if [REW LIVE TV] stops for the followingconditions, as long as the setting is [Auto], a newrecording starts automatically in a condition thatmakes the recording available.)• Other channels selected• Locked channel selected• Invalid channel selected• No TV signal• External input selected• When the full-screen application (TV Guide, MediaPlayer, eHELP, etc.) is launched• When the TV enters Standby or is turned off• When another recording starts