Panasonic TX-32PM1 Service Manual

Also see for TX-28PM1: Operating instructions

Contents

Panasonic TX-32PM1 Service Manual Manual pdf 3 page image

ALIGNMENT SETTINGS(The figures below are nominal and used for representative purposes only.)1. Set the Bass to maximum position, set the Treble to minimum position, set the Volume to minimum then press thedown button (-/v) on the customer controls at the front of the TV and at the same time press the INDEX button on theremote control, this will place the TV into the Service Mode 1.2. Press the RED / GREEN buttons to step up / down through the functions.3. Press the YELLOW / BLUE buttons to alter the function values.4. Press the OK button after each adjustment has been made to store the required values.5. To exit the Service Mode, press the "N" button.Alignment Function Setting indicationNote: All setting values are approximate Settings / Special featuresEAROM copy TV/EXT ---FLASH program copy EXT -> TV ---Horizontal Position H-Pos-15 Optimum setting.Vertical Position V-Pos10 Optimum setting.Horizontal Amplitude H-Amp85 Optimum setting.Vert. Amplitude V-Amp22 Optimum setting.EW-amplitude EW-Amp 1- 20 Optimum setting.Lower Corner Lower Corner5 Optimum setting.Trapezium-comp Trapez 1-4 Optimum setting.Upper Corner Upper Corner3 Optimum setting.Vertical Linearity V-Lin24 Optimum setting.Vertical Symmetry V-Sym-12 Optimum setting.Angle Angle2 Optimum setting.Bow Bow-2 Optimum setting.DVCO DVCO-1Receive a PAL Colour Bar Pattern. ForDVCO alignment press "Blue" button, waituntil the figure colour is changed from redto black colour.HighlightLowlightHigh 0451 0401 0380Low 0270 0277 0256 Optimum setting.Sub-Brightness Sub-Brightness7 Optimum setting.