32AV Select and SetupIt is possible to connect a variety of additional equipment to this TV. The following pages detail how toconnect external equipment to both the front and rear of the TV.Once your equipment is connected, use the following procedure to view the input:Press the TV/AV menu buttonPress the relevant on screen selector key to select the AV source you wish to view (forexample, press the green button to select AV2 if you have connected a video recorderto the AV2 SCART socket).The on screen selector keys that appear clear after a few seconds. If you want to selectan input when the keys are not shown, press the TV/AV key once more and the keyswill reappear.Notes:D This television may automatically switch over to the AV mode if the connected device sends aswitch signal to the SCART cable connector. In this case, the “EC” will be displayed in the left topcorner of the screen and the signal from the AV equipment (for the RGB signal the “EC/RGB” will bedisplayed).The picture received will remain the same when the TV programme is changed.D You may switch back to the television by pressing button “TV/AV” or by disconnecting the AVdevice.D You can also select an AV source using the TV/AV button on the control panel on the front of yourTV. Press the TV/AV button repeatedly until you reach the AV source you wish to view.D When in AV mode a reduced number of options are available in the SOUND and SETUP menus(eg: in the Setup menu there is no Tuning menu option).Front socketsS---VPress andrelease to openCAMCORDEROutput fromHeadphones socket3.5mm StereoPlugSTEREO HEADPHONESwith 3.5mm PlugVideo input toS---VideosocketVideo inputto V socketAudio inputto L / RsocketsRCA Videocable2 x RCAAudiocablesNotes:D Additional equipment and cables shown are not supplied with this TV set.D For S---Video socket wiring information see page 34.AUDIO / VIDEO CONNECTIONSTV/AVTV/AV