25AV Select and SetupIt is possible to connect a variety of additional equipment to this TV. The following pages detail how to connect external equipment to boththe front and rear of the TV.Once your equipment is connected, use the following procedure to view the input:Press the TV/AV menu buttonPress the relevant on screen selector key to select the AV source you wishto view (for example, press the green button to select AV2 if you haveconnected a video recorder to the AV2 SCART socket).The on screen selector keys that appear clear after a few seconds. If youwant to select an input when the keys are not shown, press the TV/AV keyonce more and the keys will reappear.Notes:D This television may automatically switch over to the AV mode if theconnected device sends a switch signal to the SCART cableconnector. In this case, the “EC” will be displayed in the left topcorner of the screen and the signal from the AV equipment (for theRGB signal the “EC/RGB” will be displayed).The picture receivedwill remain the same when the TV programme is changed.D You may switch back to the television by pressing button “TV/AV” or by disconnecting the AV device.D You can also select an AV source using the TV/AV button on the control panel on the front of your TV. Press the TV/AVbutton repeatedly until you reach the AV source you wish to view.D When in AV mode a reduced number of options are available in the SOUND and SETUP menus (eg: in the Setupmenu there is no Tuning menu option).Front socketsAdditional equipment can be connected at the front of the TV via a 4 pin S ---Video socket (AV3), RCA Audio / Video sockets (AV3)and a headphone socket.Press and release to openCAMCORDERSTEREO HEADPHONESwith 3.5mm PlugOutput fromHeadphones socketAudio inputto L / R socketsVideo inputto V socket2 x RCAAudiocablesRCAVideocable3.5mm Stereo PlugVideo input toS ---Video socketS ---VNotes:D Additional equipment and cables shown are not supplied with this TV set.D For S ---Video socket wiring information see page 28.AUDIO / VIDEO CONNECTIONSTV/AVTV/AV