Panasonic TX-15LT2F Operating Instructions Manual

Panasonic TX-15LT2F Operating Instructions Manual Manual pdf 23 page image

23Tuning your VCR and satellite receiverYour new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a Scartconnection is preferable if the VCR is so equipped (see page 6 or 32 for suitable inputs to the Scart socket on this TV.)However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture orsound from your VCR on programme position ‘0’ of the TV. Either adjust the tuning of the TV’s programme position‘0’ (follow the instructions below) or adjust the RF channel of your VCR (some VCRs allow adjustment of their RFchannel via their remote control unit) or both until the TV receives the RF output channel of your VCR.It is intended that this advice is used in conjunction with the instruction books for your additional equipment.Tuning your TV to the VCR.Switch on the VCR, insert and play a pre-recorded tape with known content.1 Press SET UP.2 Move to chosen Tuning menu option by using or .3 Access Tuning menu by using or .4 Move to chosen Manual tuning by using or .5 Access Manual tuning by using or .6 Select programme position ‘0’ VCR by using or .7 Start searching for the VCR playback of the known content tape by usingor .When the VCR playback is found, press STRto store.Pressing TV/AVto exit.PICTURESOUNDSET UPTV/AV02 99:21 41Manual tuningTV/AV’STR’ Button StareE x i tSerchdown / upProgrammedown / upReturnCH44VCRThe tape with known contentis found and displayed.Pressing STRwill store thesetting.Notes:• If picture patterning occurs on programme position ‘0’ it may be necessary to adjust the RF output channel of theVCR, refer to the VCR instruction book.• If a Satellite Receiver and a VCR are going to be used with RF cable connections it is important to avoid both unitsbeing set on the same channel.Refer to the Satellite Receiver and VCR instruction books for precise tuning information.VCR