- 191 -Power on LinkSet Power on Link to On in VIERA Link Settings to use this function.When the connected equipment starts playback or direct navigator / functionmenu for the equipment is activated, the TV is automatically turned on. (Onlywhen the TV is in Standby mode.)Power off LinkSet Power off Link to On in VIERA Link Settings to use this function.When the TV is set to Standby mode, the connected equipment is alsoautomatically set to Standby.● This function will work even if the TV enters Standby mode automaticallyby auto power standby function.Standby Power SaveSet Standby Power Save to On in VIERA Link Settings to use this function.The power consumption of the connected equipment in Standby mode iscontrolled higher or lower in synchronisation with the TV on / off state toreduce the consumption.When the TV is set to Standby mode, the connected equipment isautomatically set to Standby and the power consumption of the connectedequipment is automatically minimised.When the TV is turned on, the connected equipment is still in Standby mode,but the power consumption is increased to start the connected equipmentfast.● This function is effective if the connected equipment can change the powerconsumption in Standby mode and is set to higher consumption.● This function works when Power off Link is set to On.Intelligent Auto StandbySet Intelligent Auto Standby to On in VIERA Link Settings to use this function.When the TV is on, non-used connected equipment goes into Standby modeautomatically to reduce the power consumption. For example, when the inputmode is switched from HDMI or when Speaker Selection is changed to TV(except for watching a disc).● This function may not work properly depending on the connectedequipment. In this case, set to Off.
