Panasonic TH-85PF12E Operating Instructions Manual

Also see for TH-85PF12E: Operating instructions Operating instructions Brochure & specs

Contents

Panasonic TH-85PF12E Operating Instructions Manual Manual pdf 7 page image

SERIALPC INAUDIOSLOT1 SLOT3PR /CR /R PB /C B/B Y/GCOMPONENT/RGB INLANSLOT2AUDIO AUDIODVI-D IN1 2AUDIO OUTR LAUDIO OUTR L7ConnectionsStereophonic sound codeline-inaudio equipmentAUDIO OUT Terminals connectionAC cord connection (see page 11)Pass the attached cablefixing band through the clipas shown in the figure.To secure cables connected to Terminals, wrap the cable fixing band around themthen pass the pointed end through the locking block, as shown in the figure.While ensuring there is sufficient slack in cables to minimize stress (especiallyin the power cord), firmly bind all cables with the supplied fixing band.To tighten: To loosen:PullPullPush the catch– AC cord fi xingNote: Terminal board is installed in SLOT 2 and SLOT 3 at factory shipment.– Cable fi xing bandSecure any excess cables with band as required.Note:Two fixing bands are supplied with this unit. In case of securing cables at three positions, please purchase it separately.Pushuntilthe hookclicks.2. Pulloff.CloseOpen1 Plug the AC cord into the display unit.Plug the AC cord until it clicks.2 Fix the AC cord with the clamper.Note:Make sure that the AC cord is locked on both the left and right sides.1. Keep theknobpressed.Unplug the AC cordUnplug the ACcord pressingthe two knobs.Note:When disconnecting the AC cord,be absolutely sure to disconnectthe AC cord plug at the socketoutlet first.From SERIALTerminal onComputer(see page 9)From inputon audioamplifier(see page 7)From EXTERNALmonitor terminalon Computer(see page 8)DVI-D IN Terminals(equivalent of DVI-DTerminal Board(TY-FB11DD))(see page 10)OptionalTerminalBoard InsertSlot (covered)COMPONENT/RGB INTerminals(see page 10)LAN Terminal(see page 18)