1/2SignalInput labelECO Mode settingsSetupScreensaverWobbling OffOSD Language English(UK)Component/RGB-in selectRGBNo activity power offDisableScreensaverStartModeFinish TimeStart TimeTime Designation6 : 1512 : 30PRESENT TIME MON 15 : 00ScreensaverStartModeOperating TimePeriodic TimeInterval12 : 003 : 00PRESENT TIME MON 15 : 00ScreensaverStartModeScreensaver durationStandby after SCR Saver6 : 15PRESENT TIME MON 15 : 00213Automatically shifts the display image (therefore unnoticeable to the eye) to prevent image retention of sharper contourof image.Press to display the Setup menu.Press to select “Wobbling”.Press to select “On” or “Off”.On: Shifts the position of the display image on a fixed timeinterval .Press to exit from adjust mode.Notes:• If “MULTI DISPLAY Setup” is set to “On”, this function does not operate.• When this function is operating, part of the screen may appear to be missing.Wobbling32After selecting Time Designation, Interval or Standby after SCR Saver, the relevant Time Setup will become availablefor selection and the Operating Time may be set. (Time cannot be set when “Mode” is “On” or “Off”.)Press to select Start Time / Finish Time(When Time Designation is selected).Press to select Periodic Time / Operating Time(When Interval is selected).Press to select Screensaver duration(When Standby after SCR Saver is selected).Press to setup.button: Forwardbutton: BackNote: Timer function will not work unless “PRESENT TIME” is set.Notes:• Pressing “ ” or “ ” button once changes the Time 1 minute.[However, switching occurs every 15 minutes when Periodic Time is selected.]• Pressing “ ” or “ ” button continuously changes the Time by 15 minutes.• “Screensaver duration” of the “Standby after SCR Saver” can be set from 0:00 to23:59. When this is set to “0:00”, “ Standby after SCR Saver” will not be activated.Screensaver (For preventing image retention)Setup of Screensaver Time