Panasonic TH-80LF50W Operating Instructions Manual

Contents

Panasonic TH-80LF50W Operating Instructions Manual Manual pdf 25 page image

25Adjusting POS. /SIZEH-Pos Adjust the horizontal position. V-Pos Adjust the vertical position.H-Size Adjust the horizontal size. V-Size Adjust the vertical size.ClockPhase(During RGB and PC input signal)Eliminate the flickering and distortion.Dot Clock (During RGB and PC input signal)Periodic striped pattern interference (noise) may occur when a striped pattern is displayed. If this happens,adjust so that any such noise is minimized.Over scan Turn image over scan On/Off.Configurable signals are as follows:525i, 525p, 625i, 625p, 750/60p, 750/50p (Component Video, DVI, HDMI)On OffNotes:• “Off” is effective during only “16:9” aspect mode.• When “Off” is set, “H-Size” and “V-Size” cannot be adjusted.1:1 PixelModeAdjusts the display size when 1125i or 1125p signal is input.Notes:• “On” is effective during only “16:9” aspect mode.• Select On when you would like to replay 1920 × 1080 input signal.• Applicable input signal;1125 (1080) / 50i · 60i · 24sF · 24p · 25p · 30p · 50p · 60p• Select Off when flickering is shown around the image.• H-Size and V-Size cannot be adjusted when On is selected.Off OnWhile the Pos. / Size display is active, if either the N button on the remote control is pressed at any time or the ACTION ( ) button ispressed during “Normalise”, then all adjustment values (except “Clock Phase” and “Dot Clock”) are returned to the factory settings.Helpful Hint ( / Normalise Normalisation)