Specifi cationsTH-58PF20ER TH-65PF20ERPower Source 220 - 240 V AC, 50/60 HzPower ConsumptionPower on 560 W 660 WStand-by condition Save off 1.2 W, Save on 0.7 W Save off 1.2 W, Save on 0.7 WPower off condition 0.3 W 0.3 WPlasma Display panel Drive method : AC type58-inch, 16:9 aspect ratioDrive method : AC type65-inch, 16:9 aspect ratioScreen size 1,284 mm (W) × 722 mm (H)× 1,473 mm (diagonal)1,434 mm (W) × 806 mm (H)× 1,645 mm (diagonal)(No.of pixels) 2,073,600 (1,920 (W) ×1,080 (H))[5,760 × 1,080 dots]Operating conditionTemperature 0 °C - 40 °CHumidity 20 % - 80 %Applicable signalsColour System NTSC, PAL, PAL60, SECAM, Modified NTSCScanning format 525 (480) / 60i · 60p, 625 (575) / 50i · 50p, 750 (720) / 60p · 50p, 1125 (1080) / 60i · 60p · 50i ·50p · 24p · 25p · 30p · 24sF, 1250 (1080) / 50iPC signals VGA, SVGA, XGA, SXGAUXGA ···· (compressed)Horizontal scanning frequency 15 - 110 kHzVertical scanning frequency 48 - 120 HzConnection terminalsLAN RJ45 10BASE-T/100BASE-TX, compatible with PJLink™AV IN VIDEOAUDIO L-RBNCRCA Pin jack × 21.0 Vp-p (75 Ω)0.5 VrmsHDMI TYPE A ConnectorCOMPONENT/RGB INY/GPB/CB/BPR /CR /RAUDIO L-RBNCBNCBNCRCA Pin jack × 2with sync 1.0 Vp-p (75 Ω)0.7 Vp-p (75 Ω)0.7 Vp-p (75 Ω)0.5 VrmsDVI-D INAUDIODVI-D 24 PinContent ProtectionStereo mini jack (M3) × 1Compliance with DVI Revision 1.0Compatible with HDCP 1.10.5 VrmsPC INAUDIOHigh-Density Mini D-sub 15 PinVBS (use HD port)Stereo mini jack (M3) × 1Y or G with sync 1.0 Vp-p (75 Ω)Y or G without sync 0.7 Vp-p (75 Ω)PB/CB/B: 0.7 Vp-p (75 Ω)PR /CR /R: 0.7 Vp-p (75 Ω)HD/VD: 1.0 - 5.0 Vp-p (high impedance)with picture 1.0 Vp-p (high impedance)without picture 0.3 Vp-p (high impedance)0.5 VrmsSERIAL External Control TerminalD-sub 9 Pin RS-232C compatibleEXT SP 6 Ω, 16 W [8 W + 8 W] (10 % THD) 8 Ω, 20 W [10 W + 10 W] (10 % THD)Dimensions (W × H × D) 1,399 mm × 843 mm × 99 mm 1,554 mm × 925 mm × 99 mmMass (weight)main unit only approx. 45.0 kg net approx. 55.0 kg netwith speakers approx. 50.0 kg approx. 60.0 kgNotes:• Design and specifications are subject to change without notice. Mass and dimensions shown are approximate.• This equipment complies with the EMC standards listed below.EN55022, EN55024, EN61000-3-2, EN61000-3-3.20