Panasonic TH-65PB1E Function Manual

Contents

Panasonic TH-65PB1E Function Manual Manual pdf 13 page image

13After finishing preparation of the electronic pen and installation of the software, make settings andconnections according to the following procedure.For connection of a computer and the Interactive Plasma Display, see Display Operations of the operatinginstructions.Before using the electronic pen, make the settings below on the Interactive Plasma Display. For how tomake the settings, see Display Operations of the operating instructions.• Adjust “Pos./Size” so that the screen of the computer can be correctly displayed on the screen of theInteractive Plasma Display.• Set “Touch-Pen Mode” in the “Setup” menu of Interactive Plasma Display.Connect the included electronic pen adapter to the USB port of computer.• Connecting the electronic pen adapter starts up the elite Panaboard software automatically.• If the elite Panaboard software does not start automatically, disconnect and reconnect the electronic penadapter.Notice• Do not connect the electronic pen adapter to the computer if the elite Panaboard driver/software/bookhas not been installed yet.Install the software referring to the procedure of “Installing the Software” before connecting theelectronic pen adapter. (see page 12)To use the electronic pen, you need to register it to the electronic pen adapter.1. While pressing and holding the function button and Mouse/pen switching button together (1),slide the power switch to “on” (2).• The function indicator blinks green and red alternately. The power indicator stays off.1. Connect a computer to the Interactive Plasma Display2. Connect the electronic pen adapterCOMPUTERConnect to the USB portConnect to the InteractivePlasma Display3. Register the electronic penOperation