Panasonic TH-65BFE1W Operating Instructions Manual

Also see for TH-65BFE1W: Operating instructions Service manual

Contents

Panasonic TH-65BFE1W Operating Instructions Manual Manual pdf 7 page image

7EnglishPrecautions for useCautions when installingDo not set up the Display outdoors.• The Display is designed for indoor use.Install this unit at a location which can support theweight of the unit.• Use the installation bracket that conforms to VESAstandardsEnvironmental temperature to use this unit• When using the unit where it is below 1 400 m (4 593ft) above sea level: 0 °C to 40 °C (32 °F to 104 °F)• When using the unit at high altitudes (1 400 m (4 593ft) and higher and below 2 800 m (9 186 ft) above sealevel): 0 °C to 35 °C (32 °F to 95 °F)Do not install the unit where it is 2 800 m (9 186 ft)and higher above sea level.• Failure to do so may shorten the life of the internalparts and result in malfunctions.We are not responsible for any product damage, etc.caused by failures in the installation environmenteven during the warranty period.Do not place the display where it may be affected bysalt or corrosive gas.• Failure to do so may shorten the life of the internalparts and result in malfunctions due to corrosion.Required space for ventilation• When using the pedestal (optional accessory), leavea space of 10 cm (3 15/16 ”) or more at the top, left andright, and 5 cm (1 31/32 ”) or more at the rear, and alsokeep the space between the bottom of the displayand the floor surface.If using some other setting-up method (wall-hanging,etc.), follow the manual of it. (If there is no specificindication of installation dimension in the installationmanual, leave a space of 10 cm (3 15/16 ”) or more atthe top, bottom, left and right, and 5 cm (1 31/32 ”) ormore at the rear.)Minimum distance:aa b a: 10 cm(3 15/16 ”)b: 5 cm(1 31/32 ”)a• Operation of this unit is guaranteed up to an ambienttemperature of 40 °C (104 °F). When installing theunit in a case or chassis, be sure to provide adequateventilation with a cooling fan or ventilation hole sothat the surrounding temperature (inside the case orchassis) including the temperature of the front surfaceof the liquid crystal panel can be kept at 40 °C(104 °F) or less.About the screws used when using a wall hangingbracket that conforms to VESA standardsInchmodelScrew pitch forinstallationDepth ofscrewholeScrew(quantity)65 400 mm × 400 mm 19 mm M6 (4)Be careful of the movable structure of the powerindicator and remote control sensor.• As factory default, the power indicator and remotecontrol sensor are stored in the main unit. Innormal cases, pull the remote control sensor boxfrom the end face of the unit until it gets locked atthe designated position. Depending on the setupcondition such as when using the multi display, storethe remote control sensor in the main unit. (see page19)Depending on the temperature or humidityconditions, uneven brightness may be observed.This is not a malfunction.• This unevenness will disappear while applying currentcontinuously. If not, consult the distributor.