Panasonic TH-58PF20U Operating Instructions Manual

Also see for TH-58PF20U TENTATIVE: Operating instructions Product speci?cation Manual de instrucciones

Contents

Panasonic TH-58PF20U Operating Instructions Manual Manual pdf 53 page image

SYNCSIGNAL [ RGB ]3 : 2 PULLDOWNXGA MODEAUTOOFFAUTOH-FREQ.V-FREQ.kHzHz63.9860.02SIGNAL FORMAT 1280×1024/60V-FREQ. Hz60.02DOT CLOCK FREQ. MHz108.0SIGNAL FORMAT 1280×1024/603 : 2 PULLDOWNSIGNALOFFSDI THROUGH OFF[ Digital ]NOISE REDUCTION OFF53SET UP for Input SignalsThis function operates only during input from PC IN terminal.Select SIGNAL from the “SET UP” menu during RGB or Component input signal.SYNCDisplays the frequency and the type of the current input signal.This display is valid only for COMPONENT/RGB/PC and Digital input signal.Display range:Horizontal 15 - 110 kHzVertical 48 - 120 HzThe dot clock frequency is displayed during digital signal input.Input signal displayPress to select the “SYNC”.Press to adjust.Press to select the “SDI THROUGH”.Press to select “ON” or “OFF”.ON: Enables active through.OFF: Disables active through.Set the active through function of the Dual Link HD-SDI Terminal Board (TY-FB11DHD).Note:Settings can only be performed for this menu when a slot mounted with a Dual Link HD-SDI Terminal Board (TY-FB11DHD)is selected.SDI THROUGHSetting RGB sync signalCon rm that the input is set to RGB input (this setting is valid only for RGB input signal).AUTO: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.ON G: Uses a synchronized signal on the Video G signal, which is input from the G connector.VBS: Uses a synchronized signal of Composite Sync input, which is input from the HD connector.Setting Component sync signalCon rm that the input is set to Component input (this setting is valid only for Component input signal).AUTO: The H and V sync or synchronized signal is automatically selected. If both input, it is selected the H and V sync.ON Y: Uses a synchronized signal on the Video Y signal, which is input from the Y connector.Note:Accepts only RGB signals from COMPONENT/RGB IN terminal with “SYNC ON G”.