6EnglishSafety PrecautionsTouch panelCarefully observe the following instructions as the display has an optical touch panel.Do not expose the display to direct sunlight or strong light source during use.• Otherwise malfunction may occur since the optical touch panel of the display uses infrared rays.After turning on the power of the display, do not touch the IR transmission partand the screen until any image is displayed.• Otherwise the touched part may be detected as defective elements, resulting inabnormal operation. If this occurred, turn the display off and then on.Always use a fi nger or the supplied pen to operate the touch panel. Do not use a hard or sharp tip such asnail, ball-point pen, and pencil.When using any other infrared device, keep a distance to prevent erroneous operation.IR transmission partWired LANWhen setting up the Display at a place, where electric statistic occurs often, take a suffi cient anti-staticmeasure before start using.• When the Display is used at a location, where static electricity occurs often, such as on a carpet, communicationsof the DIGITAL LINK and the wired LAN are disconnected more often. In that case, remove static electricity andthe noise source that may cause problems with an antistatic mat, and re-connect the DIGITAL LINK and the wiredLAN.• In rare cases, the LAN connection is disabled due to static electricity or noise. In that case, turn off the power ofthe Display and the connected devices once and then re-turn on the power. Connect the DIGITAL LINK and theLAN.The Display may not work properly due to strong radiowave from the broadcast station or the radio.• If there is any facility or equipment, which outputs strong radiowave, near the installation location, set up theDisplay at a location sufficiently far from the source of the radiowave. Or, wrap the LAN cable connected to theDIGITAL LINK terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.LCD DisplayDeclaration of Conformity (DoC)“Hereby, Panasonic Corporation declares that this Display is in compliance with the essentialrequirements and other relevant provisions of the Directive 1999/5/EC.”If you want to get a copy of the original DoC of this Display, please visit the following website:http://www.doc.panasonic.deAuthorized Representative:Panasonic Testing CentrePanasonic Marketing Europe GmbHWinsbergring 15, 22525 Hamburg, GermanyThis Display is intended to be used in the following countries.Albania, Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France,Germany, Greece, Hungary, Italy, Iceland, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway,Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey, United KingdomThe wireless LAN feature of this Display shall exclusively be used inside buildings.