Panasonic TH-47LFT30W Operating Instructions Manual

Also see for TH-47LFT30W: Brochure Specification Brochure Service manual Operating instructions

Contents

Panasonic TH-47LFT30W Operating Instructions Manual Manual pdf 4 page image

ivPower cableTo keep the waterproof property, do not loosen the part fixingthe power cable to the main unit.Do not force to bend the protruding part of the power cable.This may cause disconnection.Protective coatingCabinet aluminum parts and rear face are protected from corrosion with coating. Be careful not to damagethe surface. In case the surface is damaged, corrosion may occur from there.Installation position• When direct sunlight is on the screen, black shadow may appear. This will disappear when the temperaturedrops.• To install the product long term in a special environment such as near a swimming pool, hot spring, or ocean, or ina factory uses chemicals or gases, please consult your local Panasonic dealer beforehand.• The product is equipped with cooling fans and air filters that need to be cleaned or replaced if covered with dust. Removingor installing air filters requires space around the Display. With this in mind, provide adequate space when installing the Display.[Height 7.874”/200 mm or greater, Width 7.874”/200 mm or greater, Depth 7.874”/200 mm or greater]ddddd d dd d dd:7.874”/200 mm or greaterInstallation conditionsTo use the product in an environment where outdoor air temperature is lower than 39 °F (4 °C), make sureto set the “Winter Mode” to “On”. The inside temperature is kept constant and the startup can be performedsmoothly. (see page 40)Do not exhibit or use this product in a condition where water splashes on to it continuously for long time.Always use the product at an ambient temperature in the range of 32 °F - 113 °F / 0 °C - 45 °C (during WinterMode: -4 °F - 113 °F / -20 °C - 45 °C).Use the product at ambient temperatures up to 104 °F/40 °C at an installation site where the display screenis exposed to sunlight.To install on a wall etc.• Consult your dealer about fittings etc. beforehand.• Choose a permanent position where the total weight of the product and fittings can be hold permanently. If thestrength of the position is not sufficient, a serious accident such as fall may be caused.• Do not install the product where a person can be hang or lean on, or a passer may collide into. Accident may becaused.• Take measures for tipping over and fall with an assumption of a fitting or installation location failure.• Installation strength may be degraded due to aging depends on the environment. Ask a installation professional toinspect or repair regularly.• When an abnormality or fault such as loose screw is detected, ask an installation professional or your dealerimmediately for repair.• Panasonic will not be responsible for any damages from an accident such as defect of installation, improper use,modification, or natural disaster.Precautions for InstallationMain unit bottom