Panasonic TH-103PB1U Operating Instructions Manual

Also see for TH-103PB1U: Operating instructions Operating instructions Brochure & specs

Contents

Panasonic TH-103PB1U Operating Instructions Manual Manual pdf 48 page image

48SETUP for PORTRAITPress to select VIEWING AREA or LOCATION.Press to select each function.Notes:• For HD signal videos, the “VIEWING AREA” is set at “16:9”,and cannot be changed.HD signal: 1125 (1080) / 60i • 50i • 60p • 50p • 24p • 25p • 30p• 24sF, 750 (720) / 60p • 50p, 1250 (1080) / 50i• When “VIEWING AREA”is “16:9”, the aspect mode is set to “FULL”.5Press to select VIDEO WALL UNIFORMITY.Press to select “OFF” , “ON”.Reduces the peak of brightness for each display to enable as uniform display as possible.The brightness depends oneach display’s setting.The brightness differenceis minimized.OFF ONNote:If you set VIDEO WALL UNIFORMITY to ON,the following menus will be unavailable andthese settings will be xed to the initial values.PICTURE menu: COLOR, TINT, INPUTLEVEL (ADVANCEDSETTINGS)VIDEO WALL UNIFORMITYOFFPORTRAIT SETUPSEAM HIDES VIDEOOFF1OFFVIDEO WALL UNIFORMITYVIEWING AREALOCATION16:9PORTRAIT SETUPOFFPORTRAIT SETUPSEAM HIDES VIDEOOFF1OFFVIDEO WALL UNIFORMITYVIEWING AREALOCATION16:9PORTRAIT SETUP4VIEWING AREA: Set a mode of image division for PORTRAIT function.LOCATION: Set a location of image to be displayed for PORTRAIT function.VIEWING AREA / LOCATIONWhen PORTRAIT SETUP “ON”:Display the image of the selected LOCATION.When PORTRAIT SETUP is “OFF”:Represent an area of the selected LOCATION at a normalbrightness and darken the rest of it.LOCATION settingVIEWING AREA and LOCATIONThe mode of image division and the LOCATION by setting of VIEWING AREA is as follows.LOCATION 1 LOCATION 2 LOCATION 3LOCATION 1 LOCATION 2 LOCATION 3VIEWING AREA: 4:3Suitable to display FULL images. NORMAL(4:3) images extend transversely.Both right and left sides of the image arecut by 48 dots.VIEWING AREA: 16:94:3 images are displayed without changingaspect ratio.Although the images of each LOCATIONoverlap, you can adjust POS./SIZE to displaythe image normally. (see page 24)Undisplayed area (48 dots)