Panasonic SC-BT100P-K Operating Instructions Manual

Also see for SABT100 - BLU-RAY DVD HOME THEATER SOUND SYSTEM: Operating instructions

Contents

18RQT9129Enjoying the FM/AM radioManual tuning1 Press [FM/AM] to select “FM” or “AM”.Main unit: Press [SELECTOR].2 Press [6, 5] to select the frequency.Main unit: Press [X] or [W].≥When a radio broadcast is being received, “TUNED” lights in thedisplay.≥When a stereo broadcast is being received, “ST” lights in thedisplay.≥To start automatic tuning, press and hold [6, 5] until the frequencystarts scrolling. Tuning stops when a station is found.Presetting stations manuallyUp to 30 stations can be set in each band, FM and AM.1 Press [FM/AM] to select “FM” or “AM”.2 Press [6, 5] to select the frequency.3 Press [OK].“P” and “M” begin to flash.4 Press the numbered buttons to enterpreset channel number.≥To select a 1-digit numbere.g., “1”: [1] > [OK].≥To select a 2-digit numbere.g., “12”: [1] > [2].≥A station previously stored is overwritten when another station is stored in the samechannel preset.≥Repeat steps 2 to 4 to set other stations.Selecting the preset channels1 Press [FM/AM] to select “FM” or “AM”.2 Press the numbered buttons to select the channel.≥To select a 1-digit numbere.g., “1”: [1] > [OK].≥To select a 2-digit numbere.g., “12”: [1] > [2].Alternatively, press [:, 9] or [2, 1] to select thechannel.If noise is excessiveWhen “FM” is selectedPress [FM MODE] to display “MONO”.≥Press the button again to cancel the mode.≥The mode is also canceled when you change the frequency.≥This setting can be preset for each broadcasting station. When“MONO” appears follow procedures 3 and 4 in “Presetting stations manually”(> above).When “AM” is selectedPress [AM BP] to select “AM BP1” or “AM BP2” that receives good reception.Each time you press the button:AM BP1(.AM BP2 (BP=Beat Proof)FM frequency stepMain unit onlyThe step is factory-set to 0.2-MHz (200-kHz), but you can change it to receivebroadcasts allocated in 0.1-MHz (100-kHz) steps.1 Press [SELECTOR] to select “FM”.2 Press and hold [SELECTOR].After a few seconds the display changes to show the current minimum frequency.Continue to hold the button down. The minimum frequency changes and the step ischanged.To return to the original step, repeat steps 1 and 2.After changing the setting, previously preset frequencies will be cleared. Preset themagain.[OK][2, 1][FM MODE][AM BP][6, 5][:, 9]Numberedbuttons[FM/AM][SELECTOR] [X], [W] TUNEDSTTUNEDMe.g., “12”e.g., “12”NOTE MONOTUNEDTUNEDe.g., “AM BP1” is selected.