Panasonic S24GPWR Operation Manual

Also see for S24GPWR: Operation manual

Contents

Panasonic S24GPWR Operation Manual Manual pdf 15 page image

153.2. IP Address ConfigurationConfigure the IP address settings of this Switching Hub in "Interface configurationmode." Confirm the configuration information by entering "show ip conf" in "Privi-leged mode."IP address configuration commandGlobal configuration mode ip address

[]

Default gateway configuration commandGlobal configuration mode ip default-gateway IP address display commandPrivileged mode show ip confExample 1: Configuration example of IP address as 192.168.0.1, subnet mask as255.255.255.0, and default gateway as 192.168.0.254S24GPWR> enableS24GPWR# configureS24GPWR(config)# ip address 192.168.0.1 255.255.255.0S24GPWR(config)# ip default-gateway 192.168.0.254S24GPWR(config)# endS24GPWR# show ip confMAC Address : xx:xx:xx:xx:xx:xxIP Address : 192.168.0.1Subnet Mask : 255.255.255.0Default Gateway : 192.168.0.254S24GPWR#Fig. 3-2 Display of the IP address configuration(show ip conf)Note: Unless you configure these settings, you cannot use remotely connect to theSwitching Hub via Telnet or the web management function. Be sure to config-ure. If you are unsure of the settings, consult the network administrator. AnyIP addresses on the local network must be unique, and no duplication isallowed. In addition, you need to set the subnet mask and the default gate-way, which are the same for other devices on the same subnet using thisSwitching Hub.