Panasonic Plasma TX-P42G15B Operating Instructions Manual

Also see for VIERA TX-P42G15B: Brochure & specs Service manual Service manual Service manual Service manual

Contents

Panasonic Plasma TX-P42G15B Operating Instructions Manual Manual pdf 83 page image

On screen messages●Frequently Asked Questions● FAQs, etc.83Message Meaning / ActionAll tuning data will be erased “Shipping Condition” will erase all tuning data (p. 47).●Are you sure ? Confirm correct operation.●Are you sure you want to delete this timer ?Press OK to delete timerPress RETURN to returnConfirm correct operation.●Bad signalThe signal is weak. Check the aerial is plugged in properly. It may●be necessary to have an aerial installer check the signal and aerialalignment.Reset channels. (p. 34 and p. 35)●Child Lock is active !Press OK to enter PIN.The selected channel is locked in Child Lock (p. 45). You must enter the●PIN number before the channel will be displayed.Ethernet cable not connectedCheck the connection of the LAN cable. If you use a hub, also check the●light on the hub is lit.The LAN cable might be defective.●Faulty dishThe satellite cable might be short-circuited or there might be connection●problems of the cable. Check the cable and connection and then turn theTV Off with the Mains power On / Off switch, and turn it On again.If the message still persists, it may be necessary to have a dish installer●check the dish and cable.Feature not availableIt is not possible to record from COMPONENT, HDMI or PC. Connect the●recorder to the TV using a fully wired SCART cable for recording from theTV tuner.Confirm Q-Link or VIERA Link settings (p. 64 - 67).●Found new software version ∗∗∗.Press OK to start update(may take 40 mins)or Press EXIT to ignoreand you can update when TV is in standby.There is a new software available.●Gateway does not answer.Please confirm connection and setting ofrouter.A connection failure has occurred and the gateway is not responding.●Check the settings and connections of the router.Turn the TV and the router Off with the Mains power On / Off switch, and●turn them On again.Invalid operation - Please check settingsand connections. Check the Q-Link or VIERA Link connection and setting (p. 64 - 67).●Invalid system time. Please exit ! Cannot get the time information. Check the connection of the RF cable.●IP address conflictDuplicate IP address has been detected. Check the IP address of other●equipment such as computers, routers and ensure that there are noduplicate IP address.IP address not set An IP address is required to use interactive content through the internet.●Enter an IP address.Manual IP setting not correct The system is unable to set the IP address. Consult your Internet Service●Provider or telecommunications company.Max. number of Timers already set ! The maximum number of timer programming events is 15.●New channels found!Press OK to update channel listPress EXIT to ignore.There may be new channels available.●This message will appear each time a change is made by the●broadcasters. This message can be deactivated by setting “New ChannelMessage” to Off in “DVB Tuning Menu”.Selecting OK will perform “Update Channel List”.No channel found.Please check aerial or local signalavailability.Press OK to start Auto Setup.Please follow the message.●If it is still failed, consult your local Panasonic dealer.No module inserted Check the CI module inserted completely (p. 49).●No recording - Check media The tape or disc may be “write protected”, missing or damaged.●No recording - Already recording The equipment may already be recording.●No recording - Unknown reason The recording may not be performed. Check the equipment.●Disc or tape may be full.●No service The broadcaster has stopped the service. Check the channel in the TV●Guide. (p. 18 and p. 19)No signal The TV cannot detect the signal. Check the connection of the RF cable.●On screen messages