Menu
Panasonic PT-53WX54 Operating Instructions Manual
Also see for PT-53WX54: Operating instructions
                                    | |
Contents
| 
InstallationTelevision LocationThis unit can be used as part of an entertainment center. Consultyour dealer for available options.Avoid excessive sunlight or bright lights, includingreflections.Keep away from excessive heat or moisture. _nadequateventilation may cause internal component failure.Fluorescent lighting may reduce remote centre]transmitting range.Keep away from magnetic equipment, including motors,fans and external speakers.Optional Cable ConnectionsShielded audio and video cables should be used betweencomponents. For best results:Use 75-ohm coaxial shielded cables.Use appropriate input and output connectors, that matchyour component connectors.Avoid long cables to minimize interference.AC Power Supply CordCAUTION: TO PREVENT ELECTRIC SHOCK,MATCH WIDE BLADE OF PLUG TO W_DE SLOTOF AC OUTLET AND FULLY INSERT DO NOT _olarizedplugUSE A PLUG W_TH A RECEPTACLE OR OTHEROUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TOPREVENT BLADE EXPOSURE.PROTECT POWER CORDS FROM BEING WALKED ON, ROLLEDOVER, CRIMPED, BENT, OR PINCHED, PARTICULARLY AT PLUGS,CONVENIENCE RECEPTACLES, AND THE POINT WHERE THEY EXITFROM THE APPARATUS.Cable / Antenna ConnectionFor proper reception, either a cable or antenna connectionis required.Cable Connection rncom_ngCablefromCable CompanyConnect the cable supplied by your localcablecempany to ANTi connection on _.back of television. Select ANT1 and Cablemode in SET UP menu.Note: A cable converter box may be 75OhnIVHF/UHFOn baCJ_ Of IVrequired for proper reception.Check with your local cablecompany for compatibility requirements.Antenna ConnectionFor proper reception of VHF/UHF channels, an external antennais required. For best reception an outdoor antenna isrecommended.Connect home antenna to ANT1 enc0mingCablefr0mconnection on back of television. HomeAntennaSelect ANT1 and TV mode in theSET UP menu. :Note: Cable Mode is preset at thefactor_ Antenna users mustchange to TV Mode and ANT 1 it)the Set Up menu./NS TALLA T/ONRemote Control Battery InstallationRequires two AA batteries (supplied).Procedure1. Turn the remote control face down. Remove batterycover by pressing down on the marking on the coverand sliding it off in the direction indicated.2. Install batteries matching (+) and (-) polarity signs.3. Replace the battery cover by sliding in reverse until thelock snaps.Note: Incorrect installation cat) cause battery leakage andcorrosion that will damage the Remote ControlPrecautionsReplace batteries in pairs.Do not mix battery types (zinc carbon with alkaline).Do not recharge, heat, short-circuit, disassemble, orbum batteries.50 |
Related manuals for Panasonic PT-53WX54
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved