Panasonic PT-50LCZ70 Operating Instruction

Also see for DVDLS91 - PORTABLE DVD PLAYER: Owner's manual Operating instructions Operating instructions Operating instructions Operating instructions

Contents

Panasonic PT-50LCZ70 Operating Instruction Manual pdf 25 page image

25 Basic OperationFirst Time SetupFor your convenience, First Time Setup menu willbe displayed on screen when the set is turned onfor the first time. If needed, follow the menus andprocedures displayed on-screen for setting up thefeatures.LanguageThe language of the on-screen display is set to Englishas the factory setting. You can select English, Spanish orFrench as the on-screen display language.Procedure1. Press ▲▼ to select “Language”.2. Press OK to display the Language menu.3. Press ◄► to select “English,” “Español” or“Français”.4. Press RETURN to go to previous screen.Auto programYou can scan All (Analog and Digital) channels. Ifneeded, follow the menus and procedures displayedon-screen for setting up the features. You can also makethe settings in Setup menu.Procedure1. Press ▲▼ to select “Auto program”.2. Press OK to display the Program channelmenu.3. Press ▲▼ to select “ANT in”.4. Press ◄► to select “Cable” or “Antenna”.LanguageAuto programPictureFirst time setupLanguageAuto programPictureFirst time setupLanguage EnglishLanguageLanguage EnglishLanguageLanguageAuto programPictureFirst time setupLanguageAuto programPictureFirst time setupANT inAutoCableProgram channelANT inAutoCableProgram channel5. Press ▲▼ to select “Auto”.6. Press OK to display the Auto program menu.7. Press ▲▼ to select “All channels”, “Analogonly”, or “Digital only”.8. Press OK to start scan.Channels available for reception will be set automatically.9. After Auto program is complete, the unit willreturn to Manual program mode. To placethe channels that were located by auto scanin memory, move the cursor to “Apply” andpress OK. (p. 27-28)If OK is not pressed after selecting APPLY,the channels will not be memorized.10 . Press ▲▼ to select “Picture”.11 . Press OK to display the Picture menu. (p. 35)NotesAfter “Auto program” is completed the unit tunes to the firstchannel found during “Auto program”.If setup is incomplete, check connection of Antenna/Cable tothe RF IN Terminal, then try “Auto program” again. (p. 26-27)“Auto program” must be done when you select the inputsignal for the first time or whenever you change the antennaconfiguration.Depending on conditions, “Auto program” may take a while.•••••ANT inAutoCableProgram channelANT inAutoCableProgram channelAll channelsAnalog onlyDigital onlyAuto programAuto programScanning digital channelProgressQuit 40%All channelsAnalog onlyDigital onlyAuto programAuto programScanning digital channelProgressQuit 40%LanguageAuto programPictureFirst time setupLanguageAuto programPictureFirst time setup