Panasonic PPDW12 Product Features Manual

Also see for PPDW12: Product instructions

Contents

technical specifications

Panasonic PPDW12 Product Features Manual Manual pdf 2 page image

Camera Housings & Mounting Hardware 111TECHNICAL SPECIFICATIONS ®7The outdoor pressurized dome camera housing shall be a Panasonic model PPDW12 or equivalent. The housingshall be designed for the Unitized Surveillance Device Series WV-CS654/CS404/BS304/BS504. The housing shallbe capable of withstanding a total of 5 psi of nitrogen gas injected through a Schraeder valve located on the 3⁄8"machined aluminum retaining ring. A pressure relief valve located next to the Schraeder valve will provide anescape for pressure exceeding 5 psi. Two (2) o-ring seals shall be included, 0.136" x 12" (inner diameter) and0.136" x 15" (inner diameter). A 10-pin hermetically sealed connector, located in the back of the pressurizedhousing shall provide power, video and control functions. A stainless steel retaining cable will be used tocapture and hold the housing’s aluminum top during service. The housing shall be constructed of 0.090"aluminum, UV stable ABS plastic, stainless steel and acrylic. The lower dome portion shall be constructed ofdistortion-free cast acrylic (free blown) and be 12" in diameter. The housing shall include an integral 10-gaugepowder coated steel wall mount bracket. The housing shall include a camera mounting bracket that integrates aheater, blower, video and power surge protector capable of clamping differential mode voltage between 24-36Vand common mode voltage from 54-72V. The housing shall be powered with 24VAC (60Hz) and have a powerconsumption not to exceed 68W including Unitized Camera. The blower shall draw 1.4W continuous power. The50W heater shall turn on at 40°F and turn off at 60°F. A ground isolation transformer, Panasonic modelPWBT1621, shall be available as an option . The housing shall support a temperature range of 20° to 120°F. Theunit shall have a weight not to exceed 18.5 lbs. (without camera) and dimensions of 14.9"H x 18.09"W x 18.25"D.PPDW12 Pressurized DomeCamera HousingGENERAL SPECIFICATIONSConstruction Pressurized enclosureanodized aluminumTop 0.090" 3003 aluminumDome Cell cast acrylicWall Mount Bracket 10-gauge powder coatedsteelSunshield ABS plastic UV stableSeals 2 o-rings: 0.136" x 12" (ID)and 0.136" x 15" (ID); 2 typesof materialPressure Relief Valve 5 psiSchraeder Valve Nitrogen inputPower Connector 10-pin Souriau, hermeticallysealedPower Source 24VAC, 60HzPower Consumption 68WDimensions 14.9"H x 18.09"W x 18.25"DWeight 18.5 lbs.Weights and dimensions shown are approximate.Specifications subject to change without notice.ARCHITECTS’ AND ENGINEERS’ BID SPECIFICATIONS

/ 3

Related manuals for Panasonic PPDW12