Panasonic NC-ZA1 Operating Instructions Manual

Also see for NC-ZA1: Operating instructions

GB36Dispenser:Clean the dispensing spouts weekly or if used intensively, clean it frequently.Clean the dispenser from the inside and outside with warm water and a suitablebrush to remove any residue and prevent mould from forming.1 Press the left side of the doorwith the dispenser to open.(P. GB11)2 Press the dispenser upwards.Pull the distribution hoselightly from the inner side ofthe door and pressing to theleft so that it clicks out of thefastener. Then remove thedispenser. 1 Place the dispenser in the upper positionback into the door and push it slightlyand slide it down until top of door high.2 Pull the hose from inner side of the door opening and press it tothe right into the holder and push the funnel-shaped part of thehose back into the collar until it fits perfectly. HolderDispenserCollar3 Make sure top of the door and dispenser are same high, andclose the door firmly.Cleaning when spout is clogged1 Disassemble the dispenser. Grip and pull the loose hose end near to thespring and pull both hose ends with the sleeve ends out of the spout.2 Pull the sleeves out of hoses  and disconnect the hoses from theconnecting piece . Pull the hose and spring together from connectingpiece .3 Leave the parts immersed in a milk system cleaner for several hours.Refer to the instructions on the milk system cleaner for the exactquantity. Then rinse them thoroughly with clean water.4 To assemble, insert both sleeve ends and hoses back together. Insertboth sleeve ends into the small spouts 1 and press them in until theysnap in properly. Push the connecting piece into the fixing slot 2. Thenpush the hoses to the right and left under the frame 3.Note• If sleeves are inserted into large spouts, coffee is not dispensedstraight.   Correct IncorrectHow to Clean (Continued)