Panasonic LST 116 Installation And Operating Instructions Manual

Panasonic LST 116 Installation And Operating Instructions Manual Manual pdf 26 page image

5.2.6 Editing a previously saved project1 Start the setup tool.2 In the left pane, click the desired project.3 In the right pane, click the desired project data.4 Click [1. Buildings and rooms configuration].5 Follow the on-screen instructions and configure thegeneral system information.6 After you have configured the items on all of thescreens as needed, click [Complete] whenprompted.5.2.7 Generating configuration files1 Start the setup tool.2 In the left pane, click the desired project.3 In the right pane, click the desired project data.4 Click [3. Configuration Data Generation].5.2.8 Deployment1 Connect the computer to the same network as thesystem and then start the setup tool.2 Turn on each lobby station, room monitor, and doorstation.3 If you registered each device’s MAC addressusing the setup toolEach device will download its configuration file fromthe computer and perform its own initial setup.If you did not register each device’s MAC addressusing the setup toolFollow the prompts displayed on the lobby station orroom monitor, and enter the device’s room number.Each device will download its configuration file fromthe computer and perform its own initial setup.(Note that for door stations, you must register eachdoor station’s MAC address using the setup tool inorder for the door station to be able to complete itsinitial setup.)5.2.9 Other informationConsult your dealer or the system administrator forinformation about the following.– How to perform batch settings for configuring lobbystation and card station card readers– How to configure advanced settings using a webprogramming– How to configure resident information using thephonebook tool and then sync it with the systemusing web programming (includes resident names,unlock passwords, card reader registration, etc.)– How to allow facility staff to send text messages toresidents' room monitors (available only when alobby station is used as the system's SIP server)– How to enable or disable backlight compensation forlobby station and door station cameras265. Programming