LC2HApplicable standardSafety standard EN61010-1 Pollution Degree 2/Overvoltage Category IIIEMC(EMI)EN61000-6-4Radiation interference electric field strengthNoise terminal voltage(EMS)EN61000-6-2Static discharge immunityRF electromagnetic field immunityEFT/B immunityConductivity noise immunityPower frequency magnetic field immunityEN55011 Group1 ClassAEN55011 Group1 ClassAEN61000-4-2 4 kV contact8 kV airEN61000-4-3 10 V/m AM modulation (80 MHz to 1 GHz)10 V/m pulse modulation (895 MHz to 905 MHz)EN61000-4-4 2 kV (power supply line)EN61000-4-6 10 V/m AM modulation (0.15 MHz to 80 MHz)EN61000-4-8 30 A/m (50 Hz)2. PC board mounting type3. CommonTypeItem PC board mounting typeInput method Non DC voltage inputNo. digits 8 digitsRated operation voltage 3 V DCAllowable operation voltage range 2.7 to 3.3 V DCCurrent consumption Max. 30 μA (max. 250 μA during reset input)Max. counting speed 2 kHz 30 HzCountinputMin. input signal width(ON: OFF = 1:1) 0.25 ms 16.7 msInput method Non-voltage input using contacts or open collector connectionInput impedance When shorted: Max. 10 kΩWhen open: Max. 750 kΩResidual voltage Max. 0.5 VResetinputMin. input signal width 10 msInput method Non-voltage input using contacts or open collector connectionInput impedance When shorted: Max. 10 kΩWhen open: Max. 750 kΩResidual power Max. 0.5 VBreak down voltage (initial) Between charged and uncharged parts: 1,000 V AC for 1 minute.Insulation resistance (initial) Min. 100 MΩ (measured at 500 V DC) Measurement location same as for break down voltage.TypeItem Panel mounting/PC board mounting typesVibration resistance Functional 10 to 55 Hz (1 cycle/min.), single amplitude: 0.15 mm .006 inch (10 min. on 3 axes)Destructive 10 to 55 Hz (1 cycle/min.), single amplitude: 0.375 mm .015 inch (1 hr. on 3 axes)Shock resistance Functional Min. 98 m/s 2 (4 times on 3 axes)Destructive Min. 294 m/s 2 (5 times on 3 axes)Operation temperature –10 to +55°C +14 to +131°F (without frost or dew)Storage temperature –25 to +65°C –13 to +149°F (without frost or dew)Ambient humidity 35 to 85% RH (non-condensing)All Rights Reserved © COPYRIGHT Matsushita Electric Works, Ltd.