Installation of this unit Installation30Inspect the UD guide part of the gear rack onthe drawer side.≥ Use the UD guide check fixture to check all the gaps inthe connection parts of the gear rack.≥ UD guide check: pattern 1≥ UD guide check: pattern 2(for parts other than the connection with theBottom Module)≥ UD guide check: pattern 3(for the connection with the Bottom Module)UD guide check fixtureGap under 1.5 mm (0.06q)Check the gap between the gear rack on thedrawer side and the UD guide by moving thefixture down.Under 1.5 mm(0.06q)1.5 mm (0.06q) or moreRefer to thefollowing "Errorflow chart".OK ErrorGapunder 1.5 mm(0.06q)Check the gap between the gear rack on thedrawer side and the UD guide by moving thefixture up.Under 1.5 mm(0.06q)1.5 mm (0.06q) or moreRefer to thefollowing "Errorflow chart".OK ErrorGapunder 1.5 mm(0.06q)Check the gap between the gear rack onthe drawer side and the UD guide bymoving the fixture down to the BottomModule side.Under 1.5 mm(0.06q)1.5 mm (0.06q) or moreRefer to thefollowing "Errorflow chart".OK Error
