Page 7-87-7 Recognition Device MaintenanceAll recognition movements can be checked. ( APPENDIX A)Ref noThe present setting value of reference No. can be checked and changed. It can be changed by.ThresholdThe present setting value of binary threshold can be checked and changed. It can be changed by.Teach scrnWhen the reference No. set now is the block, the teaching screen appears.AreaThe area can be set as a test. The area position can be changed by . This is setby pressing Complete .RecogThe block match recognition is carried out under the condition set now.Error scrnThe screen of recognition error occurred by now can be checked at the maximum of 110 screens.The screen can be changed by .ScaleThe scale appears in the recognition screen.Cross lineThe cross line appears on the recognition screen. The position can be changed by.Ver, MemoryThe versions of present recognition system and recognition ROM appear on the recognitionscreen.The recognition system can be updated.ResetIn selecting “Area,” “Error scrn,” and “cross line,” each information can be reset.In selecting “Ref no.” “Threshold,” “Area,” and “Cross line,” each change can be adjusted.Recog unitupdate293C-E-EMA07-A01-01Cursor resps
