2.10 Connection of DECT Portable Stations198 Installation Manual2.10 Connection of DECT Portable Stations2.10.1 OverviewThe following equipment is required to connect the wireless system:CS: Cell Station (KX-TDA0142CE/KX-TDA0141CE)KX-TDA0142CE Using a CSIF CardThis unit determines the area covered by the wireless system. Up to 4 calls can be made at the sametime through each CS.• CSIF4 (KX-TDA0143)One CSIF4 card supports up to 4 Cell Stations.• CSIF8 (KX-TDA0144)One CSIF8 card supports up to 8 Cell Stations.KX-TDA0141CE Using a DHLC/DLC CardThis unit determines the area covered by the wireless system. Up to 2 calls can be made at the sametime through each CS.Note for users in EuropeThis Cell Station Unit for DECT is for connection to Panasonic PBXs in use in European countries.PS: DECT Portable Station (KX-TCA155/KX-TCA255/KX-TD7590/KX-TD7580)The Hybrid IP-PBX can support up to 256 PSs. If an EMEC card is installed in the Hybrid IP-PBX, up to 512PSs can be supported. For more details about the PS, refer to the PS Operating Instructions.RF SpecificationItem DescriptionRadio Access Method MultiCarrier TDMA-TDDFrequency Band 1880 MHz to 1900 MHz*1*1 KX-TDA600BX/KX-TDA600TW: 1880 MHz to 1895 MHzNumber of Carriers 10*2Carrier Spacing 1728 kHzBit Rate 1152 kbpsCarrier Multiplex TDMA, 24 (Tx12, Rx12) slots per frameFrame Length 10 msModulation Scheme GFSKRoll-off factor=0.5 50 % roll-off in the transmitterData Coding for Modulator Differential CodingVoice CODEC 32 kbps ADPCM (CCITT G.721)Transmission Output Average 10 mWPeak 250 mWWWW.ERTEBATGROUP.COMWWW.ERTEBATGROUP.COM
