Panasonic KX-TDA5480 Programming Manual

Also see for KX-TDA5480: Installation manual Installation manual Installation manual Getting started Programming guide

Contents

Panasonic KX-TDA5480 Programming Manual Manual pdf 35 page image

2.2 ProgrammingProgramming Guide 355. Click OK.You will see a confirmation screen.NoteIf your entry contains an invalid value, you will see an error screen. Click OK and tryagain with correct values.6. Confirm your entry and click OK.To return to the previous screen, click CANCEL.Parameter DescriptionsDN2IP EntryThe parameters indicated with "*" must be changed while the VoIP Gateway Card is in the "STOP"status (see "2.3.1 Status Control"). The changes do not have to be followed by a reboot to becomeeffective.The parameters below are used to create DN2IP entries based on the gateway entries createdpreviously (see "2.2.6 Address Translation Table—GW Entry"). The DN2IP entries associate dialednumbers and IP address of the destination; therefore, a caller can reach the destination by dialing thenumber without knowing the destination IP address.For a programming example, refer to "4.2.5 Programming the Address Translation Table" of the VoIPGateway Card Getting Started.NoteIf you are using a gatekeeper, create the DN2IP entries only for the local card. In this case, youcan create up to four DN2IP entries per card.Note that if you are not using a gatekeeper, there is no maximum number of DN2IP entries.Parameter & Description Default Value Range* Leading NumberSpecifies the leading digits in dialed numbers by whichto associate calls with the appropriate destination.For example, to associate calls with dialed numbers"950-xxxx" and "951-xxxx" with separate destinations,it is necessary to make two DN2IP entries withrespective numbers, "950" and "951".No default Max. 30 digits* Remaining Number of DigitsSpecifies the number of digits to be dialed following theleading number to access the destination.For example, if the dialed numbers are either "950-xxxx" or "951-xxxx" and the numbers "950" and "951"are specified for the parameter Leading Numberrespectively, specify the number "4" in this parameter.0 0 to 29* GW No/Group No. SelectionSpecifies the type of destination when making calls: agateway or a gateway group.GW GW,Group