1.5 During a ConversationOperations 1-43Basic OperationsCall Transfer using a DSS buttonAllows you to perform a Screened or Unscreened Call Transfer by using a DSS button.There are 2 operations, depending on whether or not One-Touch Transfer* is set.* One-Touch Transfer allows you to hold an outside call and transfer it to an extension by pressing one key. Thisfeature provides automatic hold and transfer, without pressing the TRANSFER button. System Programming isrequired to use this function.“With Transfer” modePTPress the flexible buttonassigned as the DSS button.During a conversation• The other party is placed on hold and the destination extensionis called immediately.PTPress the flexible buttonassigned as the DSS button.During a conversationPress TRANSFER.TRANSFER“Without Transfer” mode• If the destination extension does not answer the call within a pre-determined time (default:30 sec.), the call will return to you (Transfer Recall).• If there is no answer within 30 minutes after “Transfer Recall” starts, the line will bedisconnected.• When the dialed extension is busy, you may access the extension by dialing “2” (BusyStation Signaling) or “3” (Executive Busy Override) and going on-hook.• If you want to return to the held call, press the TRANSFER button or corresponding CO orINTERCOM button before the destination extension answers.• A flexible CO button can be assigned as a DSS button.• To use “One-Touch Transfer”, System Programming is required.• During a 5-party conference, you cannot transfer a call.• If you want to return to the held call, flash the hookswitch before the destination extensionanswers.• If “Hold-3” is assigned in System Programming, you must dial “20” after flashing thehookswitch.• 1.2 Proprietary Telephone Settings, “Customizing the Buttons on Your Telephone”,DSS (Direct Station Selection) Button• See the Installation Manual, Section 3, “Call Transfer – to Extension”.SLTSLTPTPTPTPT!!+Technical Manuals Online! - http://www.tech-man.com
