Panasonic KX-NCP500 Networking Manual

Also see for KX-NCP1000: Brochure & specs Specifications Installation manual Guide User manual

Contents

Panasonic KX-NCP500 Networking Manual Manual pdf 42 page image

4.2.3 Programming the Network SettingsFor successful operation of a VoIP network using the V-IPGW16 card, network settings for the PBX at eachlocation must be programmed appropriately. For a detailed discussion of related features, refer to the FeatureManual.This section details the procedure to program the network settings for the local PBX. After the programmingfor the local PBX has been done, repeat the procedure for the remote PBX with the appropriate setting values.The following procedures describe the process of programming the network settings for each numberingmethod.Programming for the PBX Code Method1. a. Under Configuration, click Slot.b. Move the mouse pointer over the small PBX imagefor virtual slots.c. Click Select Shelf.d. Move the mouse pointer over the installedV-IPGW16 card to display the menu of options.e. Click Port Property.Confirm that all ports are in service (INS).NoteWhen a V-IPGW16 card is installed, 8 ports (1–8)are available. When two V-IPGW16 cards areinstalled, 16 ports (1–16) are available.2. a. From the system menu, click CO & Incoming Call.b. Click CO Line Settings.c. Type the CO Name and assign an unused TrunkGroup Number to be used for all IP CO lines.d. Click OK.3. a. From the system menu, click System.b. Click Numbering Plan.c. Click Main.d. Click the Features tab.e. In the TIE Line Access box, type the dialing number.f. Click OK.42 IP Networking Guide Document Version 2010-084.2.3 Programming the Network Settings