Panasonic KX-HNB600 User Manual

Also see for KX-HNA101: Installation guide Quick setup Installation guide

Contents

Panasonic KX-HNB600 User Manual Manual pdf 44 page image

Alarm system features (overview)You can use the system as an alarm system. When the alarm system is triggered, such as when motionis detected or when a window or door is opened, the system can:– send a notification to your mobile devices ( “Status notifications”, Page 37)– call a pre-programmed phone number (such as your mobile phone or work phone) and play amessage to alert you to the situation ( “Alert by phone call”, Page 47)– execute a smart control scenario, such as recording camera images or turning on a smart plug( “Smart control features (overview)”, Page 49)Important:R This system is an auxiliary system; it is not designed to provide complete protection from property loss.Panasonic will not be held responsible in the event that property loss occurs while this system is inoperation.Arm modesYou can arm and disarm the alarm system by changing the arm mode. When the alarm system isdisarmed, all alarm system features are disabled.Sensors that can be used to trigger alarm system featuresThe following sensors can be used to trigger alarm system features.– Window sensors and door sensors (KX-HNS101)– Motion sensors (KX-HNS102)– Water leak sensors (KX-HNS103)– Glass break sensors (KX-HNS104)– Built-in motion sensors in outdoor cameras (KX-HNC600)– Built-in motion sensors in indoor cameras (KX-HNC200, KX-HNC210)Note:R The following sensors cannot be used to trigger alarm system features.– Built-in sound and temperature sensors in indoor cameras (KX-HNC200, KX-HNC210)– Built-in overcurrent and overwattage detection sensor in smart plugs (KX-HNA101)Triggering the alarm systemThe following explains what is needed to trigger the alarm system, and what happens when a sensor istriggered while the alarm system is armed.1 The sensor must be enabled for the current arm mode in order for it to be triggered. You can alsoselect whether or not the sensor uses entry time (explained below).R See “Alarm system settings”, Page 46.R Water leak sensors are always enabled regardless of the current arm mode. They cannot bedisabled and they are not subject to entry time or exit time.2 The alarm system must be armed in order for it to be triggered.R See “Arming and disarming the alarm system”, Page 45.R If the current arm mode is [Arm: Away], exit time is in effect beginning when the arm mode wasset. During this time, sensors cannot be triggered; this gives you time to leave the house afterarming the alarm system. The exit delay alert sounds during this time. Once exit time runs out, thealarm system is armed.44Using the app