3-7(8) After performing the steps [1], [2] and [3] above, verify that the setup of "Type:", "Transfer Mode" and "Ultra DMAMode" appears as follows on the "Primary Master" setup screen.Type: [User]Transfer Mode: [Fast PI04]Ultra DMA Mode: [Disable]PhoenixBIOS Setup UtilityMainPrimary Master [****MB] Item Specific HelpType: [User]Cylinders: [ ****]Head [ **]Sectors: [**]Maximum Capacity: ****MBMulti-Sector Transfers: [16 Sectors]LBA Mode Control: [Enable]32 Bit I/O: [Disable]Transfer Mode: [Fast PI04]Ultra DMA Mode: [Disable]F1 Help ↑ ↓ Select Item -/+ Change Values F9 Setup DefaultsEsc Exit ← → Select Menu Enter Select Sub-Menue F10 Save and Exit(9) After verifying the setup has been performed correctly, press the [ESC] key on the keyboard to return to the "Main"menu of the "BIOS Setup Utility" screen.PhoenixBIOS Setup UtilityMain Advanced Power Boot ExitItem Specific HelpSystem Time: [xx:xx:xx]System Date: [xx/xx/xxxx]Legacy Diskette A: [1.44/1.25 MB 31/2"]Primary Master [****MB]Primary Slave [None]Secondary Master [None]Secondary Slave [None]Boot OptionsMemory CacheSystem Memory: 640 KBExtended Memory: ***** KBF1 Help ↑ ↓ Select Item -/+ Change Values F9 Setup DefaultsEsc Exit ← → Select Menu Enter Select Sub-Menue F10 Save and Exit