Panasonic HX-A100D Owner's Manual

Also see for HX-A100: Basic owner's manual Basic operating instructions How to upgrade firmware Firmware upgrade

Contents

- 20 -∫ If the connection between this unit and the smartphone has beeninterruptedThe connection between this unit and the smartphone may be interrupted temporarily depending onradio wave conditions.An attempt to reconnect is made automatically when radio wave interference, etc. is eliminated.Please note the following.≥ If you have been recording a motion picture or recording in the [Interval rec mode], the recordingwill continue even after the connection interruption. To stop the recording, operate this unit.≥ If Image App has been used in playback mode, if reconnecting takes 30 seconds or more, thisunit turns to recording mode and Image App will run in recording mode after the connection isrestored.≥ If this unit has been deleting files, cutting unwanted scenes or formatting, the operation willcontinue even after the connection interruption.Do not remove the microSD card while the Access lamp of this unit lights.The clock of this unit is synchronized with that of the smartphone.Synchronize to adjust the clock, etc.1 Tap # [Camera setup].2 Tap [Date & time].≥ When you want to adjust the clock, change the time of the smartphone first, and then synchronizethe time with this unit.≥ It may take approximately 60 seconds to synchronize the time of the smartphone with that of thisunit.≥ When the built-in clock battery runs down, the clock setting returns to the default state. When thebattery of this unit is in a charged state, the built-in clock battery is also charged automatically. Ifyou leave the battery in this unit in a charged state for approximately 24 hours, the built-in clockbattery stores the clock setting for approximately 4 months.≥ The setting range from 1 January 2013 through 31 December 2039 is available for timesynchronization with the smartphone.Setting date and timeWhen you start Image App connecting with this unit for the first time, a message asking you toset the date and time will appear. (This message will also be displayed if this unit remainsunused for a long period of time.)Perform Steps 2 below to set the date and time.Preparation: Connect this unit with the smartphone and start Image App. (l 17)