Panasonic HX-A100 Basic Operating Instructions Manual

Also see for HX-A100: Basic owner's manual Owner's manual How to upgrade firmware Firmware upgrade

27VQT4X90When disposing of your used products, deletepersonal information from this unit by initialisingthe network settings.≥ Disassemble after the battery runs out.≥ If it cannot be removed smoothly, contactPanasonic’s Service Centre.≥ Keep disassembled parts out of reach ofchildren.1 Open the side cover, and removeall of the 6 screws indicated in thefigure below.≥ Use a cross-slot screwdriver (commerciallyavailable).2 Remove the circuit board on thefront side (button side) of this unit,and remove the flexible circuitboard A.3 After pulling out the built-in batteryconnector B, pull out the flexiblecircuit board C, and pull out thespeaker connector D upwards.4 Remove the 4 screws indicated inthe figure below, and remove theheatsink E.5 Remove the connector F of thecamera unit, and lift up the circuitboard.6 Remove the battery by using ascrewdriver.Regarding the handling of used batteries≥ Insulate the terminals with cellophane tape orsimilar.≥ Do not disassemble.How to remove the batteryThis figure describes the disposal of thisunit, it is not instruction for repair. Ifdisassembled, repair is not possible.