GB13Press .• The tapping “ ” lamp flashes and the treatment begins.• The program lamp turns off.• Select the desired treatment type from tapping “ ”, kneading “ ”, pressing “ ”, andrubbing “ ”.• The stimulus mode does not change for the tapping treatment.• When the stimulus mode is changed, the strength of the stimulus may feel different. In this case,adjust the strength as desired.Repeatedly pressing the button changes the treatment type and the selected treatment lampflashes.The treatment type changes in this order:Changing the manual treatment Press .Repeatedly pressing the button changes the stimulus mode and the selected mode lamp lights.The stimulus mode changes in this order:Switching the stimulus mode Press .Local Wide• Switching the stimulus pattern for the treatment.• Local: Treatment is performed alternately at the pad positions.• Wide: Treatment is performed simultaneously at the pad positions.Switching the stimulus modeManual treatmentGB12Using the Low-Frequency Muscle and Nerve Stimulator (cont.)(Neck): Mainly rubs to gently loosen the neck.(Shoulder): Firmly taps to loosen the shoulders.(Joint): Relieves joint pain with fine vibrations.(Waist): Loosens the large waist muscles with a grasping massage.(Arm/Leg): Taps and grasps to loosen muscles.(Sole): Mainly taps to massage away sole fatigue.• If the attached position of the pads and the selected program are different, the programmay not be suitable for the position and the beneficial effect may not be obtained.Be sure to select the program to match the position of the attached pads.Program type• Be sure to turn off the power then change the positions of the pads.• Again turn on the power then select the desired program.When changing the treatment position• Select where to attach the pads.Program treatmentRepeatedly pressing the button changes the program and the selected program lamp flashes.The program changes in this order:Changing the program Press .