GB7ATTACHING THE PADS TO THE AREA TO BE TREATEDWipe the skin to clean off perspiration, moisture and dirt.Hold the pad grip and peel off the pad from the pad storage plateand attach the pads, one at a time, to the area to be treated.Attach the pads securely to the skin.(If a pad falls off the skin for approximately 30 seconds during operation,the power automatically turns off.)• The intensity of the stimulus between the pads may differ depending onlocation.If the stimulus is weak, move the position of the pads.Examples of attaching the padsNeckAttach the pads to the base ofthe neck.* If the pads are attached to thehead or nape of the neck, hairmay stick to the pads orstimulus to the back of thehead may increase.Joints• Emphasis on one sideAttach the pads on both sides of the jointto be treated.ShouldersAttach the pads symmetrically tothe left and right shoulders withyour backbone in the middle.Arms and legs• ArmAttach the padsone above theother on thearm.WaistAttach the pads symmetrically tothe left and right waist with yourbackbone in the middle.• LegAttach thepads oneabove theother onthe calf.• Both knees atthe same timeAttach the padsbelow the knees.Soles of the feet• Emphasis on one sideAttach the padsto the arch andthe calf.Attach the padsto the ball of thefoot and the heel.• Both feet at thesame timeAttach the padsto the arches.GB61 Without pulling on the cord, attach both pads to the pad storage plate.2 With the cord take-up switch slid in the direction ofthe arrow, hold the pad storage plate that has beenattached with both pads and pull gently.Note: If the cord takes on a bend or is twisted, the cord may become difficult to take up. In this case,gently sandwich the cord in a cloth and pull the cord to straighten as if cleaning it.If a cord gets tangled and does not come outPreparing the Cord and Pads (cont.)