Panasonic ER-VW Manual

Also see for ER-VW: Instruction manual

2ER-VWSelectable charge removal layoutNozzle angle adjustment and joint layout can be selected as desiredNozzle angle adjustment mechanismThe angles of the two nozzles can be adjusted within a range of approximately 190° by screwing down the ends ofthe nozzles. After adjusting the angle, turn the ends of the nozzles to tighten them and secure them at that angle.This allows the nozzle angles of the ER-VW to be adjusted easily after installation.Installation examplesIncludes angleadjustment scaleEasy connection layout possibleThe joint kit (optional) can be used toconnect up to a maximum of 5 ER-VWunits. The air supply part is connected viaquick connection joints, and the powersupply and input/output signals can also beconnected easily using connection cableswith connectors at both ends.Multiple ER-VW units can be connectedtogether to provide charge removal layoutsthat suit the target equipment.End connector (Accessory) Cable with connector (Accessory)AirsupplyJoint kit (1 kit required for each pair of devices)Cable with connector on both ends Used to connect power supply, input/output and ground.11 1 1 1Air joint (for replacing plug with hexagonal hole) Used to supply air.22 2 2 2Connection application exampleThin Type Ionizer High-frequency AC MethodVerticalinstallationexampleHorizontalinstallationexampleCertified byNRTL