Panasonic DP-C406 Operating Instructions Manual

Also see for DP-C266: Operating instructions Operating instructions Operating instructions Operating instructions Operating instructions

Contents

84Chapter 7 Network Settings7Network SettingsNetwork SettingsIn the Network Settings, the following items can be set.z The Key Operator Password is required to open the Network Settings screen.z After setting parameters for the Network Settings, turn the machine's power switch Off, and then On again.Key Operator Mode No. 0 - 4No. Parameter Comments Selective Item StandardSetting00 Print Network Settings Print the Network Settings list.To cancel printing the parameter setting list,select “Stop” and “OK”. While processing thecancellation, panel operation is denied, and anerror beep is produced.The feeding paper(s) will be ejected beforecompleting the above cancellation operation.If setting a parameter, an asterisk mark (*) willbe added before the parameter number.Stop, Start Start01 General 00 Ethernet• 00 MAC AddressDisplays the MAC address (Ethernetaddress).z The MAC address is displayed, but cannot beset.• 01 LAN Speed/DuplexSet the LAN speed.Auto, 10MHalf,10MFull, 100MHalf,100MFull, 1GHalf,1GFullAuto• 02 Jumbo FrameSet whether to use Jumbo Frame.This function is only available when themachine is connected to 1000 Base- TEthernet LAN.z When set to “On”, MTU (MaximumTransmission Unit) is 9000 bytes.Off, On Off01 IPv4• 00 DHCP DefaultSelect “Yes” when your network environmentis based on DHCP server.z When using this machine as a networkshared printer, select “No”, and set “01 TCP/IP Address”, “02 TCP/IP Subnet Mask”, and“03 TCP/IP Default Gateway”.No, Yes Yes