| 
16Chapter 2 General Settings No. 60 - 79No. Parameter Comments Selective Item StandardSetting60 Auto Tone Adjust If the coloured image tone has deviated, set theautomatic tone adjustment.1. Execute this mode to print the calibrationsheet.2. Place the calibration sheet on the PlatenGlass and execute this mode again.Stop, Start Stop61 Tone Adjust Reset If “60 Auto Tone Adjust” has made the originalimage tone indistinguishable, execute this modeto reset the machine to the factory defaultsetting.Stop, Start Stop65 Hard Disk Initialize Set the Hard Disk Drive format/deletion.When selecting “Deletion”, set the deletionsecurity level of hard disk data. During thedeletion time, the machine cannot be used.• StopDeletion is not executed.• MediumDeletion is completed within 2 hours.• HighDeletion is completed within 3 hours.• Format:Stop, Start• Deletion:Stop, Medium, HighFormat(Stop)66 Hard Disk Error Check Set the hard disk error check.z Not required in the Copy mode, but neededwhen installing options with advancedfunctions.Stop, Start Start67 Data Deletion of HD Set deletion security level of hard disk data forevery copy/print job.z Every copy/print job data is automaticallydeleted after each job is completed. Forhigher security, select “Medium” or “High”,however, the deletion time increases with theincrease in security level.Basic, Medium, High Basic68 HD Drive LockSettingsSet the 32-digit HD Drive Lock password.When the Set Hard Drive Lock is selected, themachine requires rebooting, and the “ChangeLock Password” and “Release Drive Lock”tasks must be carried out.Set Hard Drive Lock Set HardDrive Lock70 SD/USB MemoryFunctionSet whether to use SD Memory Card and USBFlash Memory.No, Yes Yes72 EWS Output Queue Set whether to display the print job informationin the Output Queue on the Status screen of theEmbedded WEB.z Up to 10 print jobs can be displayed.Off, On On73 Config. EditorPasswordSet the password for the Configuration Editor. Up to 30 characters |
